Hi all,
I have a powervelocity controller and wanted some help with wiring.
3 main questions:
1. The ignition input plug has an orange and a red wire, what signals go in here? - I have a switched 72V signal which I would assume goes on the orange side but what is on the red side?
2. does the throttle input to the controller remain unconnected when passing the throttle input through the BT module
3. Has anyone got some kind of DIY manual as information online is sparse and often unclear.
Also quick side question:
MXUS V3 temp input is on the white wire but when measuring resistance between the white wire and black hall sensor GND, I get no measurement on both sets. Am I doing something wrong?
I have a powervelocity controller and wanted some help with wiring.
3 main questions:
1. The ignition input plug has an orange and a red wire, what signals go in here? - I have a switched 72V signal which I would assume goes on the orange side but what is on the red side?
2. does the throttle input to the controller remain unconnected when passing the throttle input through the BT module
3. Has anyone got some kind of DIY manual as information online is sparse and often unclear.
Also quick side question:
MXUS V3 temp input is on the white wire but when measuring resistance between the white wire and black hall sensor GND, I get no measurement on both sets. Am I doing something wrong?