maximusdm wrote: ↑
Jan 14 2020 4:59am
Really appreciate the answer! Can you please post some pictures with the custom tools? My problems are now only with the pull/push of the sensor to the frame.
Hopefully this is the part of the puzzle you are missing, I worked out how to get the torque sensor out with the image below from the repair manual.
With all circlips, washers, bearings and seals removed from both sides of the motor axle as well as the sprag bearing drive wheel you need to put the axle back in from the motor side and gently tap the end of the axle from the motor side, as sort of shown in the image, this will push the torque sensor out. Having something ready on the chainring side to catch the 3 small springs that sit behind the torque sensor is a good idea as they are easily lost if they drop to the floor.
Be careful of the torque sensor wires as they are quite delicate.
To refit the sensor I lay the bike on it’s side, torque sensor side up, if on the floor you have to get your head down low to make sure you have everything lined up before tapping the torque sensor back in, reassembly with the motor out on a bench is easier.
Unfortunately I have no other pictures.
Hope this helps.