Get all your technical information about electric bikes here.
-
danmar713 100 µW
- Posts: 9
- Joined: May 29 2018 9:33pm
Post
by danmar713 » Mar 25 2020 9:40pm
Hi!
I have a Cycle Analyst v 2.4
I believe I'm at the last stage of hooking up my shunt to the controller, the shunt I am using has three additional wires (green, yellow, black) though that's what I am confused about. Do I need to use these and how would I connect them? also is there an easy way to figure out pole count? Thanks !
- ShuntWires.png (195.83 KiB) Viewed 153 times
-
Hayds13 10 mW
- Posts: 32
- Joined: Dec 25 2014 12:48pm
- Location: Sydney, Australia
-
Contact:
Post
by Hayds13 » Mar 26 2020 5:19am
i dont think you need to use the 3 throttle wires for v2.4 CA, as your throttle will be directly connected to the controller. re pole count...maybe google your motor
-
danmar713 100 µW
- Posts: 9
- Joined: May 29 2018 9:33pm
Post
by danmar713 » Mar 26 2020 3:21pm
Yeah I didn't think I was supposed to connect but wanted to be 100%. Thanks for the reassurance!