teslanv
1 MW
Any recommendations for a USA seller of the Domino Throttle?
I have a project that I want to try it out on.
I have a project that I want to try it out on.
teslanv said:Any recommendations for a USA seller of the Domino Throttle?
I have a project that I want to try it out on.
Doctorbass said:Is there any cheaper source than the 90$ one for these great throttle grip?
Doc
flat tire said:Domino is inexpensive for what you get, which is the highest quality ebike throttle commonly available. But that doesn't mean it's the best possible quality.
Yeah a high end, ball bearing (or whatever) throttle would be cool. I would buy one if it was higher quality than domino. I think a good price point would be ~$250.
potatonet said:Would love to see a ball bearing half throttle for Electric motorcycles, similar to this domino or the Hirschman E throttle.
I saw a kit for Arlen Ness ball bearings and have found some throttle + Brake control issues on an Alta, want half throttle, much safer than these full throttle kits on that bike.
E5J7R said:Can anyone please help me wire my domino throttle. I understand where the positive negative and signal wires connect with the pins and waterproof connector... but what about the other two spots (last two out of five connections in connector). The diagram says they are green ?? I don’t know what the heck that means... I’m a newb btw in case u can’t already tell.
Sounds good I want oneDasDouble said:Do you guys think a ball-bearing Throttle would be over-engineered? Im currently designing one and think about this idea as well.
E5J7R said:Sounds good I want oneDasDouble said:Do you guys think a ball-bearing Throttle would be over-engineered? Im currently designing one and think about this idea as well.
E5J7R said:Sorry I’m dumb lol what does a microswitch do? I hooked it all up without the green wires and got a throttle error And motor cut off. Two places. First while sitting at zero throttle ... then as I turn it , the error goes away. Then after about 75% turn of throttle then it gives the error again which stops the motor and it won’t start again until I fully untwist the throttle and twist again... which make the thing pretty much useless to me. Uggg. I read could be as problem die to my controller possibly having a resistor that is a hig/low voltage safety cutoff. And it trips that when the domino gives a too low or too high voltage. Is there a workaround? Thanks
Ps are the green wires for regenerative breaking? My controller is to basic for that fancy stuff
fechter said:E5J7R said:Sorry I’m dumb lol what does a microswitch do? I hooked it all up without the green wires and got a throttle error And motor cut off. Two places. First while sitting at zero throttle ... then as I turn it , the error goes away. Then after about 75% turn of throttle then it gives the error again which stops the motor and it won’t start again until I fully untwist the throttle and twist again... which make the thing pretty much useless to me. Uggg. I read could be as problem die to my controller possibly having a resistor that is a hig/low voltage safety cutoff. And it trips that when the domino gives a too low or too high voltage. Is there a workaround? Thanks
Ps are the green wires for regenerative breaking? My controller is to basic for that fancy stuff
You probably need to add fixed resistors in series with pins 1 and 3 so the output will be 1-4v instead of 0-5v. 1.2K as I remember assuming the throttle is 5k.
The microswitch is intended for a contactor. I would just not use those wires on a brushless motor.