Hi all, maybe this topic has been raised somewhere but i could not find. Hope someone can support me!
I finally upgraded both TSDZ2 and 850C to the latest OS version, but no startup, after 20sec the 'error brakes' is shown. As far is i could find this points to a communiction error. So i checked a lot of older versions and v05.0 beta 3 is the one that starts. Later versions did not at least.
When i swithc on the v0.5.0 beta 3 values are 'running'; values for battery, speed and power are changing constantly, even without activating anything
I used the DIY cable for programming the TSDZ2, must be OK as both flashing and veryfying shows no errors.
Regarding the 850C i'm not that sure as i (assume) here we just do the flashing, no veryfying.... but flashing just starts for any version after press on the (remote) power button of the 850C. Is there a way to check the flashing otherwise?
For programming the 850 C i used the DIY version to acc. https://github.com/OpenSource-EBike-firmware/TSDZ2_wiki/wiki/Flash-the-firmware-on-860C-850C-using-bootloader
Hope this sounds familiar to one of the users.
For now i would like to have 'any' version to switch back to be able to use my velo (that is where i installed it).