StudRock
100 W
- Joined
- Jul 11, 2018
- Messages
- 171
@ Cowardlyduck - Thank you for the information, I never knew that tester existed. I'll be taking a look at that. While I'm not saying it couldn't be the throttle or possible a bad controller, I would think it would be something in around what I was working with (i.e. removing the connectors and pulling the rear tire). Last night I looked at some of my posts before I got sick a few months back. I was working with 1abv and he was suggesting that I look at the phase wires and connectors as that is more than likely the problem. He suggested looking at the wires and upgrading them and the connectors to 10 gauge wires.
@ Theodore, Thank you for the reply back sir... I hope you are doing well.!! - To your comment, yes, I had the wheel off and reconnected more times then I care to say. I did clean all of the connections and sprayed them with t-9. Yes, although it is challenging to put that connector back, I feel 98% confident that it was connected as best I could. Again, looking back at what 1abv suggested, I decided to disassemble the hub and replace the wires as suggested with 10 gauge wire. I'm happy to report the a few connectors were corroded and loose and there was corrosion on 2 of the phase wires where the insulation was cut.
I'm going to order 10 gauge silicon phase wires, however, I'm at a loss for the type of connectors I need. Does anyone know what they are called...? I'm assuming I can order everything from Amazon. Oh, and do they make a replacement kit or anything for the hall sensor and temp wire..?
Thanks guys, I really appreciate all of your help..
@ Theodore, Thank you for the reply back sir... I hope you are doing well.!! - To your comment, yes, I had the wheel off and reconnected more times then I care to say. I did clean all of the connections and sprayed them with t-9. Yes, although it is challenging to put that connector back, I feel 98% confident that it was connected as best I could. Again, looking back at what 1abv suggested, I decided to disassemble the hub and replace the wires as suggested with 10 gauge wire. I'm happy to report the a few connectors were corroded and loose and there was corrosion on 2 of the phase wires where the insulation was cut.
I'm going to order 10 gauge silicon phase wires, however, I'm at a loss for the type of connectors I need. Does anyone know what they are called...? I'm assuming I can order everything from Amazon. Oh, and do they make a replacement kit or anything for the hall sensor and temp wire..?
Thanks guys, I really appreciate all of your help..