107mph go kart on 28S/18P pack of Molicel P26A
-
- Posts: 492
- Joined: Mar 03 2018 1:06pm
- Location: Augusta, GA U.S.A
- Contact:
107mph go kart on 28S/18P pack of Molicel P26A
107 mph electric gokart at the dragstrip….
https://www.facebook.com/24718481265088 ... 78783/?d=n
Components:
AC-9 motor from HPEVS
1238E controller (650A max)
28S/18P lithium ion battery pack consisting of Molicel P26A cells connected with .25mm pure copper bus bars (pack assembled by Vextrek in Augusta, GA)
Thunderstruck BMS and Charge Controller
https://www.facebook.com/24718481265088 ... 78783/?d=n
Components:
AC-9 motor from HPEVS
1238E controller (650A max)
28S/18P lithium ion battery pack consisting of Molicel P26A cells connected with .25mm pure copper bus bars (pack assembled by Vextrek in Augusta, GA)
Thunderstruck BMS and Charge Controller
-
- Posts: 492
- Joined: Mar 03 2018 1:06pm
- Location: Augusta, GA U.S.A
- Contact:
- liveforphysics 100 GW
- Posts: 14329
- Joined: Oct 29 2008 1:48am
- Location: Manhattan Beach, CA, USA
- Contact:
Re: 107mph go kart on 28S/18P pack of Molicel P26A
Possible to show a vid that is visible to non-facebookers?
Each carcinogen vapor exposure includes a dice roll for cancer.
Each mutagen vapor exposure includes a dice roll for reproductive genetic defects in your children.
Each engine start sprays them into a shared atmosphere which includes beings not offered an opportunity to consent accepting these cancer experiences and defective genetics life experiences.
Every post is a free gift to the collective of minds composing the living bleeding edge of LEV development on our spaceship.
Each mutagen vapor exposure includes a dice roll for reproductive genetic defects in your children.
Each engine start sprays them into a shared atmosphere which includes beings not offered an opportunity to consent accepting these cancer experiences and defective genetics life experiences.
Every post is a free gift to the collective of minds composing the living bleeding edge of LEV development on our spaceship.
-
- Posts: 492
- Joined: Mar 03 2018 1:06pm
- Location: Augusta, GA U.S.A
- Contact:
Re: 107mph go kart on 28S/18P pack of Molicel P26A
Yes sir. It’s actually good to know that not everyone is on Facebook. I need to do the sameliveforphysics wrote: ↑May 14 2022 11:23pmPossible to show a vid that is visible to non-facebookers?

https://youtu.be/P5kUjMHM3Qs
-
- Posts: 492
- Joined: Mar 03 2018 1:06pm
- Location: Augusta, GA U.S.A
- Contact:
Re: 107mph go kart on 28S/18P pack of Molicel P26A
Cells are connected with .25mm thick pure copper sheets.
- liveforphysics 100 GW
- Posts: 14329
- Joined: Oct 29 2008 1:48am
- Location: Manhattan Beach, CA, USA
- Contact:
Re: 107mph go kart on 28S/18P pack of Molicel P26A
Can you share the 60ft, 330ft, and 1/8th?
Each carcinogen vapor exposure includes a dice roll for cancer.
Each mutagen vapor exposure includes a dice roll for reproductive genetic defects in your children.
Each engine start sprays them into a shared atmosphere which includes beings not offered an opportunity to consent accepting these cancer experiences and defective genetics life experiences.
Every post is a free gift to the collective of minds composing the living bleeding edge of LEV development on our spaceship.
Each mutagen vapor exposure includes a dice roll for reproductive genetic defects in your children.
Each engine start sprays them into a shared atmosphere which includes beings not offered an opportunity to consent accepting these cancer experiences and defective genetics life experiences.
Every post is a free gift to the collective of minds composing the living bleeding edge of LEV development on our spaceship.
-
- Posts: 492
- Joined: Mar 03 2018 1:06pm
- Location: Augusta, GA U.S.A
- Contact:
Re: 107mph go kart on 28S/18P pack of Molicel P26A
Yes sir. Here you go. These times were not so good. Going to try a larger sprocket on the rear axle to improve the lower end acceleration. I am still accelerating at the 1/4 mark so I believe I can keep the same top speed and improve the lower end acceleration.
-
- Posts: 12252
- Joined: Aug 03 2010 10:33pm
- Location: Sydney ..(Hilly part !) .. Australia/ Down under !
Re: 107mph go kart on 28S/18P pack of Molicel P26A
Karts are an aerodynamic brick !...anything above 30mph pumps power into the wind.
You could reduce that time, and increase top speed if you just tilted the seat back to a “laydown” position.
You could reduce that time, and increase top speed if you just tilted the seat back to a “laydown” position.
This forum owes its existence to Justin of ebikes.ca
-
- Posts: 492
- Joined: Mar 03 2018 1:06pm
- Location: Augusta, GA U.S.A
- Contact:
Re: 107mph go kart on 28S/18P pack of Molicel P26A
Good point. Might try that. Thanks.
- liveforphysics 100 GW
- Posts: 14329
- Joined: Oct 29 2008 1:48am
- Location: Manhattan Beach, CA, USA
- Contact:
Re: 107mph go kart on 28S/18P pack of Molicel P26A
Nice kart! I see a lot of ET to be dropped in shorter gearing my friend.
Each carcinogen vapor exposure includes a dice roll for cancer.
Each mutagen vapor exposure includes a dice roll for reproductive genetic defects in your children.
Each engine start sprays them into a shared atmosphere which includes beings not offered an opportunity to consent accepting these cancer experiences and defective genetics life experiences.
Every post is a free gift to the collective of minds composing the living bleeding edge of LEV development on our spaceship.
Each mutagen vapor exposure includes a dice roll for reproductive genetic defects in your children.
Each engine start sprays them into a shared atmosphere which includes beings not offered an opportunity to consent accepting these cancer experiences and defective genetics life experiences.
Every post is a free gift to the collective of minds composing the living bleeding edge of LEV development on our spaceship.
-
- Posts: 492
- Joined: Mar 03 2018 1:06pm
- Location: Augusta, GA U.S.A
- Contact:
Re: 107mph go kart on 28S/18P pack of Molicel P26A
I think you’re right. Will try again this Thursday and hopefully will lower the ET. In theory, I could get a slightly higher TopSpeed since I was no where close to the maximum RPMs with the other sprocket. Definitely will keep you guys posted. Thanks so much for all the great info on this forumliveforphysics wrote: ↑May 17 2022 12:44amNice kart! I see a lot of ET to be dropped in shorter gearing my friend.
- DogDipstick 100 kW
- Posts: 1387
- Joined: Aug 19 2018 12:39pm
- Location: Fleetwood Pa
Re: 107mph go kart on 28S/18P pack of Molicel P26A
Hahaha way to go Gary.
84v of Ironhorse XC..
by Chevy
You call .. that.. a "glitch:" ?
(...No Mom. The formula is Kaw > 1(Hr) = Impounded. The math checks out. I'll be fine. )..
Broke20Horsies! 17,830w !!
1 (pound / second) Hp = 338.24 M^2 Kg^2 / Sec^4 (
1200v?
)
isn't 13" x 27".. Oh nvrmnd
4+25% = 5 ; 5-20% = 4... 5(1-20%) = 4.. so, to correct the incorrect reading, of 4 ... 4(1+25%) = 5
Fabricator @BSECo.












-
- Posts: 492
- Joined: Mar 03 2018 1:06pm
- Location: Augusta, GA U.S.A
- Contact:
Re: 107mph go kart on 28S/18P pack of Molicel P26A
