danielrlee
10 kW
Hi all. During my morning commute today, my rear wheel hub motor developed a clicking noise. Upon inspection, it appears that I have stripped a couple of teeth from one of the planetary gears.
Two questions:
1) Does anyone know where I can get a set of replacement planetary gears? A UK supplier is preferred, but isn't important.
2) How do I remove the existing gears from the motor? I cannot see any obvious means to further dismantle the stator:
There is a C-clip at the other end of the axle (not shown), but I don't have any replacements for if I were to remove it, so I haven't attempted it yet.
Also, there are six screws around the circumference of the red part (not sure what it's called) in the image below, but again, I don't want to blindly take this thing apart:
So, any ideas? Thanks in advance for any assistance you are able to provide.
Dan.
Two questions:
1) Does anyone know where I can get a set of replacement planetary gears? A UK supplier is preferred, but isn't important.
2) How do I remove the existing gears from the motor? I cannot see any obvious means to further dismantle the stator:
There is a C-clip at the other end of the axle (not shown), but I don't have any replacements for if I were to remove it, so I haven't attempted it yet.
Also, there are six screws around the circumference of the red part (not sure what it's called) in the image below, but again, I don't want to blindly take this thing apart:
So, any ideas? Thanks in advance for any assistance you are able to provide.
Dan.