Hummina Shadeeba
1 MW
Used the icharge 208b. Second time i used it. There were big sparks at the balance port when i plugged the battery to it. Id charged 3 batteries on lipo balance charge the first time days before and did the smar again this morn- 6 total cells(3batteries 2 cells each). The firdt time 2 cells hit 4.2 and the rest were coming up slowly...different batteries but same capacity n brand Then i went to plug all 6 cells in again today and big sparks and melted the balance port prong for two ports on the negative terminal. It said voltage problem and wouldnt charge or discharge and two cells were listed at 5.2 volts! They were listed at 4.2 days before when id charged and it was set to lipos. Also smoke came out of the fan area! Id just connected the balance leads when this happened. Ive since read i should connect the battery neg terminal last but it didnt sound like a make or break it requirement and i wonder if that couldve been the problem.
Im pissed. This is the second time i used this and the firdt time i simply was balance charging and 2 cells hit 4.2 and stopped charging and the other four were coming up so slowly it shut off itself. Id planned to charge the low ones seperately but didnt make a new cable for 4 s so tried with the six and this happened. Two of the 2s neg prongs melted, black spot on the battery balance hole where it had gone in.
Sent from space
Im pissed. This is the second time i used this and the firdt time i simply was balance charging and 2 cells hit 4.2 and stopped charging and the other four were coming up so slowly it shut off itself. Id planned to charge the low ones seperately but didnt make a new cable for 4 s so tried with the six and this happened. Two of the 2s neg prongs melted, black spot on the battery balance hole where it had gone in.
Sent from space