alpaca123

I have an RTR kit and it is great, I have used it on three different frames with different fork specs (All-axle front motor, regular QR...

The new chain came in, and it is made to spec. If you are in Canada I used this website: iDESIGN Solutions - Canada's Technology Store...

@amberwolf I have done some custom bolts/nuts in freecad for 3d printing and the helical functions in freecad worked without any issue...

Regarding freecad, I don’t quite know enough about software to explain it properly but here is an example. If you look at my motor mount...

Howdy, After watching some videos and getting inspired to go a little deeper than a grin ready to roll kit, I thought I'd post my...

I just picked up my aluminum pieces today, I will update once I have things spinning.

I ended up ordering a 7070 110Kv from amazon, and a 6384 150Kv from freerchobby. Combined including shipping they came out cheaper than...

@Hummina Shadeeba that is a pretty cool frame. My plan is to do the same with a motor mount instead of a custom bike frame, and run a...

Here’s a frame that could take a belt without modifications...

So to start off, this is my first attempt at a moped beyond a AIY kit (assemble it yourself), and my knowledge of electronics is...

I am planning something similar but I will use my existing 48v battery and baserunner. So far the difficult part is finding a motor with...

I had a question for thepronghorn which was answered along with the advice to post it up here so please see below: Howdy thepronghorn...