Search results

Date Relevance Most replies

  1. E

    TSDZ2 OSF for all displays, VLCD5-VLCD6-XH18, LCD3, 860C-850C-SW102.

    Looking forward to seeing this when it's done! Do you have any details on the belt drive you're using, I assume you're using an IGH?
  2. E

    TSDZ2 OSF for all displays, VLCD5-VLCD6-XH18, LCD3, 860C-850C-SW102.

    So does the DZ41 display work in full now, as long as you use the code that mbrusa posted? Do you need to flash it? I have an Sw102 but might swap it as the DZ41 looks a bit better
  3. E

    TSDZ2 OSF for all displays, VLCD5-VLCD6-XH18, LCD3, 860C-850C-SW102.

    Wow! It was possible all along! This is great, thank you.
  4. E

    TSDZ2 OSF for all displays, VLCD5-VLCD6-XH18, LCD3, 860C-850C-SW102.

    Is there a guide somewhere on how to wire up the light to go on when I brake? I have brake sensors installed and lights wired in. The rear light did have an extra yellow signal cable, but the cable coming from the TSDZ2 controller e.g. the speed sensor/brake splitter only seemed to have 2 wires...
  5. E

    3 battery wires TSDZ2

    Update, I borrowed a multimeter from a friend and found green = black and white = red. Still no idea about the extra black cable though, maybe someone can advise.
  6. E

    3 battery wires TSDZ2

    Hi, this may be an obvious question but I'm new to this. I've purchased a battery for my tsdz2 but the connector has 3 wires, green white and black (top in pic) and the input for tsdz2 has two wires, red and black. What's the third wire for and what should I be joining to what? I could try it...
  7. E

    TSDZ2 36v Motor 48v Battery

    Ok great - thank you both of you for your help!
  8. E

    TSDZ2 36v Motor 48v Battery

    Hey - I have ordered a TSDZ2 36v motor, and am considering getting a 48v battery as that seems better value for money (range vs size vs cost). I've read that I can install the open source software to allow this to work but I wondered what would happen if I just used it with the stock firmware...
Top