Recent content by andyb

. and as well. Hope it helps.

Hello. I just got it to work version 12 and change the dev settings on my phone so it uses Bluetooth AVRCP version AVRCP 1.6 (you need to enable developer options on your phone (very easy, google it) to get to this setting, I hope that works for you. This was done whilst powering it using the...

Hello. Same problem for me, there are some comments through this discussion about BT issues. Do you have an older phone to try, my Android 9 phone finds it without a problem, my Android 13 hasn't managed to yet, but if i do solve it i'll post here.

Thanks Mspider for getting back to me. :bigthumb:

Sorry all I didn't see that. 😳

Anyone, please.

Hello. Please can someone confirm that these look okay. Thanks.

Hello, from what I have seen it works with mbrusas OSF, check the forum and search p860c. I have bought one and will be trying to sort it this week. Hope that helps.

Thanks for getting back to me, I admit it looks a bit confusing. Can I go back to a previous version by flashing etc or would this not work? Thanks, just wanted to be sure.

Thanks, would shorting the tx and rx connections appropriately work, I could use a connector on the end of the current one. Thanks (again)

:bolt: It's Still alive :bolt: (Sort of) (Sorry Admiralrofl, I don't know about running no display) I have it all wired up and working (on one of the 2 boards I had there was a short between txl and gnd) the other one was fine. I have a problem though. It works brilliantly until I change...

:bolt: ITS ALIVE!!!!!! :bolt: Very excited :D :D :D I thought I would share my experience of flashing the board and getting the temp sensor sorted, it's all working but along the way I made some mistakes and I'm hoping by posting them others might be helped. I used this to flash I got...

Thanks for the speedy reply. :bigthumb:

Hello, I'm just about to install this and I was wondering, if I wish to try a different firmware (eg mbrusa's) at some point in the future, would I have to remove the board (I realise the Bluetooth app wouldn't work). Thanks to everyone for all the brilliant help and support on this forum and...

Hello and thanks for the reply, I was running Open source firmware TSDZ2-v20.1C.3-860C-NEW, all was going well, I swapped out the motor and display to a new bike and I think I messed up the new cables. It would power on show the menus but not flash or interact with the motor. Thanks again. Andy.