If I setup those in batteries in parallel I would have 20-30C for 10000mAh, so I would be pulling 200-300A right? Is the VESC able to handle this or am i thinking about this wrong? I dont want to do this and end up screwing my board up. Even with the XT90 connectors for parallel, it would go to...
I am using a rayne nemesis and it has a deep tub concave. It is 1.5 cm difference from the edge to the bottom of the concave which is about the middle 14cm of the board. I need an enclosure with inside space of 33cm x 16cm x 3.5cm. So the concave will not really make a difference and I will also...
I would like to use this enclosure but I am using 6 batteries. If anyone is good with 3D file editing can you please comment if you can try to edit this file. I contacted the original maker and he was going to make me one but I haven't heard back in a month. I just need it extended to fit 6...
I am looking for a case that is long enough for 6 zippy batteries. If dimensions would help, something around 30-35cm by 16cm by 3.5cm. If anyone knows of one that can be 3d printed or a site that has good containers that can be converted into enclosure please post them here. Anything helps!
Anyone who has/ knows of good accurate watt meters that will let me know when my batteries are running low, post the links. Most of the ones I see on here people say fail after a short period of time or are not accurate. Would love to know who has decent ones and where I can get them.
That would be awesome. This board may be trick though, the bottom is not flat. It is 26 centimeters wide but is only flat for about 13 centimeters in the middle and then curves. The difference at the edge is 1.5 centimeters. The battery enclosure can be 20x34x4 centimeters. The 4 centimeters is...
I'm looking for a good 3D printable enclosure for a one motor setup, VESC, 6 2S3P batteries. If anyone has links for good ones please send them. Needed for a rayne nemesis deck, looking preferably for ones in similar size or design to the boosted enclosures. Please send any links you may have...
Ok I will go with that, how do I know which belt will work for me though? Also do either of you have any old belts/ pulleys you would be willing to part with, I am having trouble finding ones that aren't coming out to 60$+ for everything and would like to know that it would work with abec clones...
I am not sure how to go about picking the best gear ratio. I have a Turnigy Aerodrive SK3 - 6364-245kv Brushless Outrunner Motor and am using a 9S2P setup for batteries and 83mm Flywheels. And info helps.
My motor has 4mm bullet connectors for the connection to my esc. I am using a VESC however which has 5.5mm female bullet connector leads. I am wondering what is the best way to make this work, cut the 4mm connectors and replace them with 5.5mm, or is there an adapter I can purchase to help with...