Recent content by danielson

Ignor the last comment just realised that is motor type. Is there a good basic setup known to work well to start with ?

Just setup the new configurator but noticed there is no option for 52V. Is there a work around for this ? Daniel

It has been a while since I have been here. I have now done around 1300km using the OSF with VLCD 5 on my Cannondale Scalpel and overall it is very good. I bought a Cube Reaction Pro with Bosch motor for my wife recently but she prefers my bike :-) . With the firmware, power level 3 (emtb) does...

Thanks, I thought I read that it would / might be possible to do it without cutting to make the swd connection soon. Have I read wrongly ?

Got my SW102 from pswpower today. Do I still need to cut it open to flash / update bootloader and firmware or can it be done via bluetooth. Recall reading that bluetooth was on the way.

I ended up installing standard 52v firmware and was able to get it to work by connecting blue to red. The power seemed around level 3 but default 25km speed limit was in place. I tried connecting the LCD again and adjusting the speed then removing the LCD but the result was the same. I ended up...

I ended up installing standard 52v firmware and was able to get it to work by connecting blue to red. The power seemed around level 3 but default 25km speed limit was in place. I tried connecting the LCD again and adjusting the speed then removing the LCD but the result was the same. I ended up...

Did some testing today and found gatorseans information was correct for my motor however connecting red to blue will not power the motor. I tried connecting red, blue and black to the corresponding wires on the LCD and although the LCD would turn on still no power from the motor. I had to...

I have been trying trying to run a new TSDZ2 with no display, have flashed firmware and settings using the configurator with default emtb mode. I thought is was as simple as joining the blue battery + V wire to the red Vin wire but dies not work.

Anyone here had any success running the TSDZ2 without an LCD ? I have been trying but no luck as yet. Below is my post from another chapter of endless. Need some help. I flashed the firmware in my new motor today and made necessary settings using marcoqs java configurator. I am waiting on my...

Did some testing today and found gatorseans information was correct for my motor however connecting red to blue will not power the motor. I tried connecting red, blue and black to the corresponding wires on the LCD and although the LCD would turn on still no power from the motor. I had to...

I read the motor controller can be enabled by simple connect green wire to white wire and this way there is no need to use LCD here https://opensourceebikefirmware.bitbucket.io/development_tsdz2/About_Tongsheng_TSDZ2_mid_drive_motors--Motor_controller.html So joinging Green P+ battery voltage to...

Perfect Thank-you

Need some help. I flashed the firmware in my new motor today and made necessary settings using marcoqs java configurator. I am waiting on my SW102 and have read that you can power the motor by joining white to green. I gave the 8 pin plug from the motor the chop and joined the white and green...

Does anybody have the pinout showing colors for the plug on the SW102 to save me cutting my loom open ?