Recent content by Ham

Ordered my next stealth gen 3 today instead of the photon so will see what kind of chain lines I can get with it when it arrives! Excited again but for no real reason as I currently run X1 Pro gen 2 which is a hoot but the stealth gen 3 torque sensing improvements excite me and hopefully a...

Excellent to hear, thank you. The poll, is better than just reading negative reports so I am hoping that it gives at least a slightly clearer idea. Right now it sits at 69 votes with 74% having no issues, 15% having problems that prevent riding and 11% having problems that don't prevent riding...

If anyone fancies helping out I have a poll going on the photon owners group to help establish reliability for people sitting on the fence to purchase, myself included... Log into Facebook

And bang on the money, I worked my way through the wiring yesterday and found it to be what I assume is the power (red wire) from said connector was very loose. I have fixed that and no more over current readings...very good of you to reply , thank you! I then spent the rest of the day...

Hi All, I am after a little help/refresher... My build (cyc gen 2 motor and box mated to domino throttle, standard cyc torque sensor, CA3 and Castle Creations HV160) has finally come out of winter storage now work has slowed down a little and in my recommissioning of the beauty I have come...

Another option indeed...not one I will be delving in to any time soon though!

OK I will have a deeper look into the torque sensor set up and see what I can find. Physically disconnecting it means more pulling apart of wire looms as it is all part of the torque sensor wiring..I'll skip that for now as the current set up is good enough :)

I just had a little play with the pole count but CA only allows a low of two to be set...which is not a fun ride:)

Interesting, thank you, I will give that a go and see what happens!

Thanks for the reply Justin, busy as you are, it is appreciated. The way you describe the wheel torque sensor sounds great to be honest...totally torque dependant?!...is there a way to try this out on a bottom bracket torque sensor set up?

OK so I have changed the start level for each pre set and now I can pedal gently and change gears without the motor engaged...perfect...many thanks! My next question is to understand just what does threshold torque setting do? I get the start torque is the amount of pedal pressure that must be...

Thank you! I will have a play around soon and feedback what I can make happen

Thanks, I managed to get it set up now :thumb:

OK so it does appear to be a glitch, not the end of the world but perhaps a future update will resolve it... downrate has always been at 14.0 but noticing the threshold issue I upped it to 99.0 just to see if it made a difference, nada. It's not a massive issue as I just stop pedalling...

Ok so it does work how I think by the looks of it. Zero start from above specific crank torque (40nm in my case) works perfectly...however once I am pedalling I assumed that if the crank torque drops below threshold torque then PAs would cease but mine carries on no matter what I set torque...