Recent content by honya96

2 hours of random numbers, found that P doesnt matter if 5 or 600... the I is the key. got best results when set at 7. thank you. any idea about the display speed getting stuck? i found that it always shows 2km-h once you touch throttle after startup, then goes to zero after first speed sensor...

@stancecoke hello, Im trying on a gear hub motor now, made a tiny little modification to this file, to try again if flashing fails, because im having problems with my st link. check if you like it. now on the hub im getting osciclation from 18 to 26kmh. no load rpm is 36kmh.. I tried speedshift...

@stancecoke Just so you know, I briefly tested the firmware on a mulitprotocol display, the push assist works on everything, on kunteng protocol it tries to run the motor with like one amp, on bafang I had to set 10 times the real gear ratio. light switch works on all protocols. the display...

One more thing I noticed. Low voltage cutoff at full throttle is kind of pulsing the power about 4 times a secound, instead of cutting it completely or maintaining the set minimum voltage. Have not tried high voltage limit because regen doesn't work, but I expect it to be there same. Maybe you...

https://drive.google.com/file/d/1f_xwssU4s3eqlIO_9zJ6aNBeWq_ES4rc/view?usp=drivesdk

@stancecoke just now tested with PLL disabled, much better, full throttle from standstill or even moving slightly backwards works great, but when it's moving just a bit forward when applying throttle it kicks for some reason and at no load there's some pulses, not noticeable while riding, just...

Siaecosys or something like that.. on Aliexpress..

Simply said, heating is not an issue. If you don't plan to have a fan pushing air through, just glue them on top of each other as you want.. let me know what capacity you got in 😉

Fully charged 21s hurts just a little, not enough to get scared and throw the battery 🤣

Search for ec8 or something like that

I had this problem too, sold the controller for profit and got one with regen lever input 😉 best solution in my opinion, I doubt you will be able to get another firmware to let you change in the app, but if you do, send it to me and I'll tell you where to connect the signal wire for brake lever...

Change in the code worked ( brake lever cuts the throttle) but it looks like the regen is not working with wheel in air.. will test tomorrow on road. Speed PLL helped maybe.. now with a little load I don't even notice the switch, but no load maybe it vibrates a bit more. Still better than that...

@stancecoke can you please point me where to change linear brake min and max voltage? im now testing on a scooter which needs regen and i have 0.9v on the brake not pressed and 3.4 when pressed all the way, so its still braking. and theres a little problem at low speed it has low power and then...

I just got third controller with the same problem, so definitely common.

So the one I have spare is F103 C8T6 so it probably won't work.. if you wonder how I can change it, I have EBICS firmware flashed, from stancecoke, so that would probably work on a fresh processor too..