Recent content by jamo96

Anyone know the maximum discharge current for the LEV40? I can only find specs of lev50 which states 300A continuous.

What max current do you get from the LEV40 cells?

Anyone have the wiring pinout for ME1616? It's a Metri-Pack 150 series 8 pin connector for the encoder and temp sense wires. Thanks

What is the status of the CAN adapter on the DVT screen? Does it say online?

7/8 inch shaft 3/16 keyway 7/16 set screw There is a technical drawing on motenergy website. http://www.motenergy.com/me0201014201.html E.g. for #40 size chain you could use something like this: https://www.rollerchain4less.com/40B14-78-finished-bore-sprocket

Okay I've got rid of the hesitating. The sound remains, especially when returning to 0rpm after spinning up. You can see in this video. https://vimeo.com/437576888

a few things to try - thanks guys. I dont have much info on the throttle apart from it taking 5v supply. I have it working now using the CycleAnalyst 5v supply so all good for the moment. Another question I have is that at 0rpm with the throttle engaged slightly the motor kind of hesitates -...

Yes the potentiometer supplies are fixed to 10v as I found out. Some later models have 5v output on pin 10 but my model - it is at batt +ve. The encoder supply is programmable to 5v or 10v but is already being used by the hall sensors. Might have to go down the regular path. Thanks

Hey all, Has anyone swapped a potentiometer throttle to a hall effect? The hall effect throttle supply required is 5v however I cant seem to find in DVT where to set the voltage. It is currently set to 10v for the potentiometer. Thanks

Great thread. I have been tinkering with my Sevcon size 4 and Motenergy 907 motor. I have a few DCF and DLD files I can upload supplied from various parties if interested. I somehow convinced Sevcon to send me a license for my newer version DVT. This was good however I was a little short...

Hey Just wondering if anyone has found a crimping tool to do AMPSeal connectors? I have looked online but seem to be all $300+. Anyone have some experience with one? Thank you

Hi all Does anyone have a copy of the DVT software they could share with me? I have the original IXXAT interface so I would be after the original version. Thanks

Config is an 8T MAC rear motor 12 FET Lyen Controller 40A current limit. It has been fine for the past 18 months. It does the vibrating thing with no load as well. It also occasionally sounds like it has no sync and emits high pitched sound when motor is trying to spin up. I'll check the...

Hi Just asking if someone has had the same symptoms, save me time testing. My MAC motor has been playing up lately. It makes a harsh vibrating sound when trying to take off from a standstill, but if you pedal up to speed it works normal-ish... its faster than usual. It will be either like this...

I like the frame and the look with fuel tank. I would prefer full electric but keep the look of gas tank and mid mount motor.