Recent content by magudaman

Sorry just updated, this is sold!!

Just updated sorry it is sold!

Hey guys sorry I didn’t update this thread it is sold!

Well I had to take a closer look at this and found out it is actually at CA-DP version 2.3. It has a 6 pin connector.

Up for sale is my 1500w BMC brushless motor. I added two Temp proves that show internal air temp and internal winding temp. The shaft is 5/8in bore with a keyway. It has hall sensors internally that work but have since lost the pin out. I will try to dig up the hall connector before the sell...

Sold!!! Up for sale is my Kelly KBS72051XS with serial adapter. The controller works great and has the high speed option for 70,000 ERPM. I paid a lot of this unit only to use it for a very short time and has been stored since. $50 Specs listed below: KBS72051X Kelly KBS programmable BLDC...

Sold! Up for sale is a perfect condition Cycle Analyst CA-DP version 2.3. This unit looks new, comes with wheel magnet. Works perfect. Located in the east Bay Area, California but could ship at buyers expense. $60 Sold sold sold

Update!!!! This is sold. Take it all for $240 Up for sale is a lot of ebike parts from an old ebike businsss. The photos show all the part you are getting but I did rough summary below: - New 10x 250w to 500w front and rear hub motors all seem to be freewheel internally - 1x 26in front wheel...

It has an abi incremental encoder not a sin cos encoder. You could always move over to VSEC controller, it is natively supported.

Well good news. Mine seems to detect with no issues so far. I used the parameters you mentioned and ran the encoder detection. Came up with 80.4 offset and ratio of 7. The real time data looks pretty flawless and smooth. Still seems a bit glitchy on startup on the bench but I need to triple...

Got all my stuff! Flipsky 75200 and my Qs165 with encoder. Hoping to get all setup this weekend to test everything on the bench! 75200 was $241 usd shipped with 10 day delivery Qs165 was $411 usd shipped with 9 day delivery

Well crap, I guess I could always run it sensorless. Motor is showing up Monday.

Really appreciate you doing this testing. I have my QS165 and a Flipsky 75200 coming hopefully next week. I will report what happens with mine, really hoping I don’t have similar issues. Turns out the noise in the line of my QS165 was coming from the motor itself. It was obvious something was...

I getting ready to purchase the qs165 for my project and keep coming across two version, a 72v and 60v. Is there actually two different winds to this motor?

Yes sir