Recent content by SarDoX

up

thanks.. Problem is that I have a nice 6s charger so I will have to stick to 4s lipo btw - I wanted to go with 3*4S = 12S total but not sure if this motor will handle this voltage. Motor max voltage is 44V, 12s lipo just charged are 12*4.2= 50.4V :cry:

TY very much! Still not clear for me how to connect 2 pin button to ADC 6pin port: 1 pin to TX and another pin to 3.3V or GND? :shock: :oops: My thottle is connected to pins: 3.3v, GND, ADC_EXT I did a detection and set up everything according to tutorial :!: , but there are still a lot a...

up

up

Hallo! I need help with VESC setup, I google a lot but cant find any similar questions My setup is Turnigy Aerodrive SK3 - 6374-192kv + VESC + 8S LIPO 16000mah 1. How to make brake button work? My throttle is usuing @ADC and works perfect, no issues here. As I understand button is a @PPM app...

Ok, so today I did a first long run Charged lipo to 4.2/cell and did a 7.63 miles on full throttle. And still 3.9 left in cells so I believe I can make up to 12 miles before voltage reaches 3.7 Motor is warm, esc is warm, nothing is overheating. Happyyyy :mrgreen: :mrgreen: :mrgreen:

whats the problem to solder wires to a pin? 60+watt iron and 3 sec to solder Just dont forget to use flux otherwise you will burn plastic on connectors ps I use Rosin Paste Flux #135 for $8.49 and Weller SPG80L Marksman 80 Watt Iron for $26.60 12V 200A should work with goped 32V80A setup but...

MrDude_1, can u check out this scheme? Im not good at electrical at all, but.. Its the scheme where I can isntall parallel board into my goped and just add an extra connector on its body to jump charger without opening the cover Is this scheme correct?

I think his ESC has option to turn on/off depending on voltage in some logic circuit. Like a signal wire in car audio.. So basically his ESC is always connected to battery but due to logic circuit in ESC it turns itself off

honestly - I have no clue how to make it charge without opening the board and disconnecting the circuit 2*4s lipos and in series, to charge them I need to plug them to parallel charging board, disconnect stabilizing wires from low voltage meter and also plug them in parallel charging board...

To turn goped on and off I did an arming switch without going into expensive 100A relays (over 100$) 2 connectors, 2 inches of wire, 1 hour of time and a couple bottles of the best Oregon beer)

So.. I ended up with "custom" connector switch The only problem here that it sparks a bit when Im inserting "the key" But.. since Im not usuing goped a lot - I think it wont make any problems

When I was going short downhill with a full throttle (may be 25mph) I did feel how unstable the scooter is. Every mini nano bump on a road makes me feel unsafe)) Especially when cars and trucks are around or right behind and you know that they cant stop as fast you fall)) I think its all about...

ohh thanks for the info right now at 20mph motor is warm not hot.. but at 30 it can be hot, even with my 130lbs do u think 25mph is going to be good? its 56/14 gearing and gear ratio is 4:1 also I saw someone added a fan to the motor from the side p.s. I dont think it safe to go 37mph even...