Recent content by Stu Summer

I had a light Kona Kikapoo with full suspension. I put a BBSHD on it but it flexed too much on acceleration. I didn't like that feel of the frame deflecting sideways. I now ride the Kona analog and have a BBSHD on a DB Haanjo aluminum cross country hardtail which is much stiffer. I do wish I...

A-DamW, thanks. It is too far down for me, or up. As you can see from my reply to Spinningmagnets, I just want to know what will work or might work. I don't need maximum efficiency. And i am out in the boonies so I don't have to worry about maneuvering thick traffic where every instant...

Spinningmagnets, thanks for your reply. What I am trying to find out is whether I can run a hub motor with one of several no-name controllers. Do I just connect the phase wires, power it up, spin the wheel and turn the throttle and see if it works? Or is some other wiring configuration or a...

I am trying to understand the disadvantages of running sensorless. Also, how do I know if my controllers will run sensorless?

With your bike with the front hub motor, what hub did you use on the back instead of the TDCM? Mainly I want to know how to get an axle long enough. Or did you just squeeze in the frame? Thanks and great work!

Thanks so much for your post. Since I have wiggled every wire many times and plugged and unplugged and changed batteries and taken apart the controller to check for loose wires, I was pleased to see another approach. I didn't check the hall sensors but your post encouraged me to return to the...

I'm happy to take it all.

Hi All. I have an old Yuba Mundo with an Ezee front hub motor system purchased from Grin (I’m not the first owner). It is a set up with a potentiometer, a CA, a pedal sensor and a 25A controller. The system was working fine. Then it was working intermittently and it seemed that fiddling with...

Yes, I have a Terrafirma adapter for my Ego batteries. The adapter works well but the screw hole pulled right out when I tried to mount using it.

Thank you, Amberwolf.

pm me your paypal ID. I'm getting your pm's, I don't know if you are getting mine. Stu

pm me your paypal id.

PM not sure if it is sending. Leave it In the wheel. I don't know which bike I will use it in yet. Will relace if necessary. Thanks, Stu 518 672 7302

I will buy it. I sent you a PM but it is not leaving my outbox for some reason. I'm at 651 Harlemville Rd, Hillsdale, NY 12529. Look up the shipping and I will paypal you. Stu Summer 518 672 7302

Okay, I have to fess up to a combination of stupidity and dyslexia (which I didn't know I had.). Turns out the problem was that the motor just does turn itself off if there isn't any load. I didn't have the chain connected and so the motor would run and then turn off. This was after...