Recent content by zappan

Hi Mspider65, I installed the new updates and everything works great! :D

"by winwar84 » Jun 02 2020 5:36pm http://www.jobike.it/forum/topic.asp?TOPIC_ID=78456 the sensor is managed by the bluetooth card" Hello, it is possible but you have to install the TSDZ2-ESP32 card of the Mspider65 project, the discussion can also be found here...

Hi, then yesterday I got the PCB that Mspider65 sent me which I thank for the great availability and courtesy, today, after identifying the corresponding colors of my controller compared to the standard ones found in the project wiki, I connected and installed with the help of my trusted...

Good, place the link where to find the latest stable version for the display LCD3 V0.20.0-beta.1 of Buba-Casainho https://github.com/OpenSource-EBike-firmware/TSDZ2-Smart-EBike/releases/tag/v0.20.0-beta.1

Hi Famichiki I tried to change the value as recommended by you and I got excellent results, I reported my experience on jobike, also because I use 152mm short cranks and with the calibration of the force applied on the torque sensor everything works much better

Hi jalabat, very nice your test I already use the high cadence mode on the engine powered at 36 and I am very satisfied, I saw on your video that when you go from 42V to 58.8V you only change the 14S battery type, but not change the motor settings (from 36V to 48V) why? when you use a native 36V...

I'm sorry stancecoke, but I just broke the news.

Hi, great news the latest release of Mbrusa works perfectly with all the original Displays :bigthumb: http://www.jobike.it/forum/topic.asp?TOPIC_ID=76426&whichpage=55...

Hi Buba and welcome back :D , I'm using it and I didn't have any wonderful work problems, I noticed though that the LCD3 actually measures the battery voltage a little higher than that measured by my WattzUp instrument, a problem that was also reported from another user here...

Thank you very good work :bigthumb: , given your competence, if you like updates of Mbrusa to the SW of Marcoq on the display on the original displays of some data (temperature, voltage etc.) you can take a look? because it works on XH18 but they are not displayed on LCD6, only the remaining...

It works perfectly for XH18 :D . Thanks again to Mbrusa for his work :thumb: , the user from here Ashambro has also tested it and displays: - the engine temperature - the remaining battery charge in percentage - battery voltage but not yet for VCLD6 and VCLD5 :( , who can help develop these...

Thanks Btslo :D

I am following this discussion and have never had the problem in restoring the original SW, but for knowledge I wonder where it configures openbyte to 28? I haven't seen it in any guide.

Hello Marcoq, I look forward to trying it :D , but you have also updated to ver. 0.20.1 of Buba because I tried it and it's fantastic! :D :D

Hi, I've updated to ver. 0.20.1 Beta and tested for a standard lap that I often do, I can say that having tried all the ver. starting from 0.07. this is the best, the response of EMTB is great, thanks Buba and congratulations. :bigthumb: