Search results

Date Relevance Most replies

  1. 317537

    Insane RPM @ 120% on a 20" Pie.. 48v battery.

    The issue exists in that it open up to WOT when I apply about 3/4 applied throttle in 120% mode. It is nice to have it as a boost switch, but you get a bit of a sore neck running it like this as a default setting, the bike takes off like a rocket in 120% speed mode. Im almost getting 150%...
  2. 317537

    Insane RPM @ 120% on a 20" Pie.. 48v battery.

    2pvO4i2XeRY Check it out the frequency is 7 tones higher so the RPM must over 25% faster in 120% mode.
  3. 317537

    Insane RPM @ 120% on a 20" Pie.. 48v battery.

    I have a 48v 20ah NMC battery hooked up to an Ecrazy 12 fet controller, running a 20" cast pie, and at 120% speed setting at 3/4 throttle the wheel RPM just goes insane and hits the roof.. So I set it up to 100% and the issue vanishes and the wheel runs perfectly normal. I ran a switch out...
  4. 317537

    MXUS 3000 Hub Motor - V1 V2 V3

    A GREAT SUGGESTION? Like the fans, instead, rivet the fin halfway covering the vent over every second hole then pull it up so it shaped like a scoop then on the inside of the plate do the same so the scoop removes the air.
  5. 317537

    Limiting power of controller (cheaply)

    If you like wasting 20kw of energy burning rubber, a few more watts on a peltier cooler wont break the bank. They are light and in this respect efficient for drag racing and the shorter runs where a larger pack is only required for amps and not long distance, The anti peltier efficiency...
  6. 317537

    Limiting power of controller (cheaply)

    You can remove a shunt. It works well on some controllers. I had one issue with V dropping as the logic power came from the controller. I ran bypass wires from the battery, as far back in the circuit, even before the BMS is practical to get the most accurate battery measurements.
  7. 317537

    MXUS 3000 Hub Motor - V1 V2 V3

    Even if the motor is not running or running slowly the out side area of most hub motors have plenty of room to give off heat, they are generally just made to achieve high RPM with as little wind resistance. The sealed motor works well for those who like to save juice, which in itself is an...
  8. 317537

    MXUS 3000 Hub Motor - V1 V2 V3

    I thought the side plates was already made from good thermal conductive material, the issue of having to make it water proof like this would make it handy just to put heat sink inside on the side plate that collects heat and acts as a fan, thermal paste to help, and another on the out side of...
  9. 317537

    Chinese Electric Scooter Log

    And are they 50v caps with a 48v sla system? If so, awesome. How you do that?
  10. 317537

    Chinese Electric Scooter Log

    The initial torque, is the shunts im sure of it, but Im not sure what I am seeing on the shunts, solder, clipper marks and scratches, this has been altered in too many ways to understand. One if not two of those shunts may not be even part of the original part. I think you can fix the...
  11. 317537

    Chinese Electric Scooter Log

    Possibly the result of all that solder on those shunts, if three are required and you sunk 48v with over current into the stator caused LVC and a spike from the motor came back and ouch. That kind of controller and those fets work for 36v and I see a lot of failures on 48v systems with regen...
  12. 317537

    EEStor ultracapacitor

    Ahhh now I get ya, youre talking about an entire different thing. The point I make is you loose farad when you series them and that you do. Any way thats what I ment. I didnt say joules you did. I put to you But what if you could maintain Farad? This is my entire argument. So now...
  13. 317537

    EEStor ultracapacitor

    Shouldn't V drop @ t/2 with series capacitors.
  14. 317537

    EEStor ultracapacitor

    Put it this way, as it is been discovered Farad increases with voltage, like if you charge a 10f cap to 5v and it is rated at 10v I theories it only has 2.5f of energy. But when you series say 2 caps, you cant use this formula because you aint doubling the voltage of a single cap.
  15. 317537

    EEStor ultracapacitor

    Here the discharge Looks a lot different for a different perspective.
  16. 317537

    EEStor ultracapacitor

    Hey I lay off the trolls. But eestor have independent tests with ED now at 345kw/l
  17. 317537

    EEStor ultracapacitor

    Something tells me C*V^2/2 broken when comparing the Joules to F in series. As both caps linearly discharge at the same time. Not like batteries where the voltage holds. Your missing a number or a function near V.
  18. 317537

    EEStor ultracapacitor

    And just you wait until you see what we going to do with TEC and TEG, it aint over until the fat lady sings. A touch of inspiration, imagination, and none of this you cant, do goes a long way. We are not expecting free energy, or some huge miracle perpetual motion machine, and there is you...
  19. 317537

    EEStor ultracapacitor

    OMG Americans.
  20. 317537

    EEStor ultracapacitor

    Series. @20v 1/ct=1/10f+1/10f .1+.1= .2 1/.2=5f @20v ---- Parallel. @10v ct=c+c 10+10=20f @10v Condensed, 10v @ 20f ...VS... 20v @ 5f, which one is better? The conclusive capacitance is quadruple in farad, by adding them in Parallel, as opposed to in series, but only double the voltage...
  21. 317537

    EEStor ultracapacitor

    It is an interesting subject some are trying very hard to avoid discussing.. If I parallel 2*10v 10 farad caps, I get 10v 20 farad, if I series them I get 20v 5 farad, ummm. Der. What I think Luke is missing, is when you add batteries in series you dont lose capacity of each cell but when...
  22. 317537

    EEStor ultracapacitor

    Sorry last post was the trolls, but what goes around will eventually come around. Ok what if I store 5 watts in one capacitor, and 5 watts in another and then series them. Do I get 10 watts or 5 watts return? Well potentially yes, but there is the plate distance issue to deal, where does that...
  23. 317537

    EEStor ultracapacitor

    Their first samples ED, around 345wh/l starts about where commercial lithium is now and is expected to crap on it in the future and the materials are not a rare commodity...
  24. 317537

    EEStor ultracapacitor

    Yes its working. And they havent pushed the samples to their maximum. The higher voltages can be used for on grid storage, something about needing silicone to do step down is a challenge but I can think of a few ways to turn UHVDCv into AC with out silicone being used..
  25. 317537

    EEStor ultracapacitor

    Excerpts: During the tour, we watched several testing procedures, including a resistivity test on newly manufactured product, a test of capacitance under varying frequencies, and an energy storage test upon varying voltages. The sample used in the DC test was manufactured on October 9, 2012 and...
Back
Top