constantly.constance
10 µW
Sorry if this is the wrong spot to post this as this is my first post on this forum and also apologize for poor grammer/ spelling and lack of understanding of things
im am in the process of building a vsett10 + scooter and plan to use a spintend 75200 ubox for dual motors and am going to be building a 20s8p so 72 volt 35amp battery using molicel p45b batteries copoer nickle sandwhich methoth
i am going to have to mount my controller externally and want to be able to have hub motor quick disconects i have been looking at 3 prong type water proof mil conectors or even found something called like a 3 pin dt conector that are water proof pure copper with 12awg pig tails
i am planning to try and bump my awg to the same as the 75200 which has 12awg for the motor phase wires i plan on running probably 50 amps but mabey higher from the controller and basically though i am concerned the connectors will eaither A melt or if they will be a limiting factor instead of using bullet connectors as most these connectors i find are only raited to 50 amps or less does any one have any recomendation or can possibly help me get better understanding of what i need
I seen a post on this similar but felt it didnt fully awnser my questions
Thank
Constance
im am in the process of building a vsett10 + scooter and plan to use a spintend 75200 ubox for dual motors and am going to be building a 20s8p so 72 volt 35amp battery using molicel p45b batteries copoer nickle sandwhich methoth
i am going to have to mount my controller externally and want to be able to have hub motor quick disconects i have been looking at 3 prong type water proof mil conectors or even found something called like a 3 pin dt conector that are water proof pure copper with 12awg pig tails
i am planning to try and bump my awg to the same as the 75200 which has 12awg for the motor phase wires i plan on running probably 50 amps but mabey higher from the controller and basically though i am concerned the connectors will eaither A melt or if they will be a limiting factor instead of using bullet connectors as most these connectors i find are only raited to 50 amps or less does any one have any recomendation or can possibly help me get better understanding of what i need
I seen a post on this similar but felt it didnt fully awnser my questions
Thank
Constance