I cannot find documentation on this controller but have been using this forum to help me get as far as I have. This is my first time wiring a controller.
I bought this off of amazon -
Mophorn 1800W Electric Brushless... https://www.amazon.com/dp/B07KF8M5W6?ref=ppx_pop_mob_ap_share
I built a 48v battery using 18650s and this BMS -
Lithium Battery Protection Board,... https://www.amazon.com/dp/B07T4HVMQK?ref=ppx_pop_mob_ap_share
I have wired the power. Phase wires. Hall sensor. E-lock (jumper). Throttle. I had to move some wires around bc the obvious plug and play didn’t work.
The motor does run. I tested the signal to the hall sensors and all but one alternates voltage. The yellow and it stays at 4.7ish. I am not sure where to go from here. At this point it doesnt matter if I have the motor hall wires plugged in, right?
I am also not sure how the reverse works or if that has to be plugged in for the motor to start.
I bought this off of amazon -
Mophorn 1800W Electric Brushless... https://www.amazon.com/dp/B07KF8M5W6?ref=ppx_pop_mob_ap_share
I built a 48v battery using 18650s and this BMS -
Lithium Battery Protection Board,... https://www.amazon.com/dp/B07T4HVMQK?ref=ppx_pop_mob_ap_share
I have wired the power. Phase wires. Hall sensor. E-lock (jumper). Throttle. I had to move some wires around bc the obvious plug and play didn’t work.
The motor does run. I tested the signal to the hall sensors and all but one alternates voltage. The yellow and it stays at 4.7ish. I am not sure where to go from here. At this point it doesnt matter if I have the motor hall wires plugged in, right?
I am also not sure how the reverse works or if that has to be plugged in for the motor to start.