I'm using sevcon controller but I had a problem with old one, so I bought a new one.
After line setting for drive, I sent DCF file saved before to the new controller.
But a warning occured like this picture,
and everytime turn on the controller DVT showed this error
And then we found "dynamic range error" & "Internal"
Even we turned the axle of the motor, sin cos range didn't changed.
What does make it happen?
Is there can solve this problem?
Thank you !
After line setting for drive, I sent DCF file saved before to the new controller.
But a warning occured like this picture,
and everytime turn on the controller DVT showed this error
And then we found "dynamic range error" & "Internal"
Even we turned the axle of the motor, sin cos range didn't changed.
What does make it happen?
Is there can solve this problem?
Thank you !