Does anyone happen to have a CAD file for the unit?
I am inspired to get a second one and hack it into something more like the Rocky Mountain Dyname 3.0 system.
Keep the lower housing and the small helical gear, off the blue gear run a 12t cog to a 44t cog on a jackshaft. The jackshaft would run a 12t to the rear cassette. It would involve flipping the output to the non drive side and switching wired so run it in reverse.
Need to figure out the torque sensor as I would like to run modern cranks instead of square taper, but could live with them short term to get it running.
I am inspired to get a second one and hack it into something more like the Rocky Mountain Dyname 3.0 system.
Keep the lower housing and the small helical gear, off the blue gear run a 12t cog to a 44t cog on a jackshaft. The jackshaft would run a 12t to the rear cassette. It would involve flipping the output to the non drive side and switching wired so run it in reverse.
Need to figure out the torque sensor as I would like to run modern cranks instead of square taper, but could live with them short term to get it running.