I have a kelly controller lying around, and I wanted to try it out with a BBSHD. Not to its full potential, probably limited to 40-50 amps once set up.
The only setting I've messed with so far is to allow it to be used with a different throttle type, and limiting the current to 10 amps so that nothing blows up in the testing phases. Without the chain attached, it was spinning pretty slow while taking ten amps, yet you could see small puffs of smoke come from the motor core and it was pretty hot.
I am guessing one of two things is possible
a) The stock programing for the KLS7230S is significantly miscalibrated/misconfigured for a BBSHD
b) I've got a bad controller.
I searched the forum and best I could find were a mention here and here, but it didn't sound like the stock configuration would cause slow speed and smoking. and this, but it doesn't seem to go anywhere. I feel bad asking what is essentially a plzbro question without searching, but searching hasn't led me to anything.. which means likely no one here is as ignorant as I am.
Is there any reference material/documentation suggested to supplement what is in the manual to help someone who is a noob to pair a brushless controller w/ hall sensor to a motor?
The only setting I've messed with so far is to allow it to be used with a different throttle type, and limiting the current to 10 amps so that nothing blows up in the testing phases. Without the chain attached, it was spinning pretty slow while taking ten amps, yet you could see small puffs of smoke come from the motor core and it was pretty hot.
I am guessing one of two things is possible
a) The stock programing for the KLS7230S is significantly miscalibrated/misconfigured for a BBSHD
b) I've got a bad controller.
I searched the forum and best I could find were a mention here and here, but it didn't sound like the stock configuration would cause slow speed and smoking. and this, but it doesn't seem to go anywhere. I feel bad asking what is essentially a plzbro question without searching, but searching hasn't led me to anything.. which means likely no one here is as ignorant as I am.
Is there any reference material/documentation suggested to supplement what is in the manual to help someone who is a noob to pair a brushless controller w/ hall sensor to a motor?