John in CR
100 TW
gensem said:im pretty sure everything else aside the hub motor was crap (even the hub had flaws) and that was before the inflation....
I take it you mean the H35 motors. It wasn't the motor, since the stator of the motor of this thread may come out of the same factory. The magnet backing ring is obviously for a moto with the XL spoke holes. They just used a bike hubbie axle and covers. Good ole Kenny just ordered the wrong combination of parts to slap together and then pawns it off as some big new deal without even testing his parts combination.
I'd trust HAL and Accountant to do it right long before putting faith in Kenny.
Flathill,
There was a complete lack of interest here in scooter hubbies 2 and 3 years ago, and the factory I tracked down was the only one I could find that did spoke flanges instead of built on rims. I tried pushing them to do some with bike friendly axles and covers, but I couldn't swing the 10,000 unit minimum they wanted for the special order. They just couldn't fathom that anyone would want to put a hubbie they use for emotos on an ebike. I on the other hand can't fathom why anyone would put a relatively low power motor on a 300lb pig. :lol:
There's all kinds of motor bargains out there, and I'm just really waiting for better controllers to drive the higher Kv hubbies I already have and the biggie which is lower battery prices for the good stuff that is safe enough to go on something for sale.