kikomania1
1 µW
- Joined
- Jan 2, 2022
- Messages
- 4
Hello,
I'm upgrading my KT controller from 25A:
to use 50A model instead:
The wires are different and all the wires in my bike are julet, so I have to adapt them.
There are two special considerations:
- The 9 pins motors = motor phase lines (3 wires) + motor hall lines (5 wires), but I don't know in which position related with the 9 pins connector.
- The 1 to 5 Cable = e-brakes x2 (6 wires) + throttle (3 wires) + display (5 wires) + front light (2 wires). Again, I didn't find a schema to know how they should be fit.
—
It's my first time doing this, and I feel so close and yet so far. Any idea/suggestion of what I can do to pair them correctly?
I'm upgrading my KT controller from 25A:
to use 50A model instead:
The wires are different and all the wires in my bike are julet, so I have to adapt them.
There are two special considerations:
- The 9 pins motors = motor phase lines (3 wires) + motor hall lines (5 wires), but I don't know in which position related with the 9 pins connector.
- The 1 to 5 Cable = e-brakes x2 (6 wires) + throttle (3 wires) + display (5 wires) + front light (2 wires). Again, I didn't find a schema to know how they should be fit.
—
It's my first time doing this, and I feel so close and yet so far. Any idea/suggestion of what I can do to pair them correctly?
Last edited: