Recent content by 33du

I have installed 100mm version to 73mm frame with machined piece of "pipe", axle is 15mm longer on 100mm (175 vs 190) version than in 68/73 so not so big difference

I solved this problem with changing to Bafang BBSHD and difference is like day and night.. about same power, no noisy and works always:)

I don't have BMS in use, only direct connections to turnigy lipos and after driving all cells have equal voltage. Probably issue is wrong gear as i have 32 front and 11-17 rear is used in forest trails, engine has cyclone cooling parts and does not cook eggs while cutting down:)

Days goes forward and I still have issues with overheating or some power cuts. I can drive in flat without pedaling like 2 km about 25km/h speed, release throttle and then engine shuts down for minute or two. In forest 100-200m with heavy pulling with pedaling and power cuts again, checked...

Looks like Truvati GXP goes to normal BSA chassis and BBSHD should fit, but this is only assumption based on google:)

Have you noticed that there are discounts on hobbyking lipos yesterday ordered 4*6S 10000mah, other set is 4*6S 500mah

Koman are you 100% sure that you have this kind of? http://www.bicimarket.com/Transmision-Pedalier-Shimano-XT-SM-BB70B-p3940.html if yes, then isis will fit, but Spezializes says that 2013 model has PF30 which can't be used as far i know

Depends from bike frame if motor can be fitted inside triangle, also place and size of controller

With that 4mm bracket is trying to turn little bit in case clamps aren't fully tightened, but no problems with chain line etc.. first i was thinking 3mm but luckily took 4:)

Friend of mine has truck repair center and there is tools to cut and bend steel, just like cutting or bending paper:) On gearbox there is some start coles for screws allready, need to drill small hole on bottom and put some metal piexe for pipe.. that's still in progress but more like ATF guys...

Hi, Some pics about weekends "upgrade". Next step might be replacing grease with oil like on ATF set Used material 4mm steel

I have used Cyclone 1680w kit now few months and it's quite noisy with full throttle. Original 44 mid sprocket is obsolute as not enough power for more speed compared to 32 (about 45km/h in flat without pedaling). 13tooth freewheel was good improvement and bike answers better to throttle on...