docw009

The LCD display should stay turned on, unless the voltage is too low at its connector.

Finally, no standard for the PAS connectors. You often have to debug that too. Three wires, power, signal, and ground from the...

You might have to adjust how you attached the sensor. The disk has to spin in the right direction, relative to the sensor. The disk...

When you put two batteries in series, the BMS transistors need to withstand the combined voltage of both batteries, or 84 volts, That's...

I didn't mention that bypass trick, but it does add a new twist to the clues. Not familiar with the M5 display at all, but that would...

No, it means the BMS can safely handle 30A. The current handling capability of a BMS depends on the transistors used in it. I saw on...

Isn't your controller inside the battery cradle? That limits you to buying an exact replacement, which you should if you wish to use the...

I guess the original poster fixed their problem. Bet he had a broken BMS wire that he didn't solder back on,. As for the BMS rating...

Concerning the apparent 11.8 max charge on each battery, try charging them separately with a 12.6V charger, Also check inside each...

You might want to look at this schematic for a KU65 controller (square wave?) sold by BMSbattery.com as a guide to how controllers are...

Motor works in walk mode. It spins with throttle, if you hold down the M button. That says motor must be good. You already changed...

I'm guessing for these amounts that were previously considered de minimis, folks will probably discover some loopholes, maybe in how the...

I've wrestled with the problem in most of my conversions, trying to fit a battery on the rear rack. My second conversion used a rack...

TSDZ2B crank gear showing its two clutches, The TSDZ2 does not have the outer sprag clutch, just a version of the inner one , which some...

It's not working fine. You're reading too high a speed. When I first installed OSF, the speedometer did not work at all, so I want back...