Hi Gary. If you recall I bought your last three lvc boards awhile back. I was having trouble getting them to activate the lvc via the brake. Â Come to find out I think 2 of the boards are bad. One of them has a transistor that gets very hot. The other is high when pack is fully charged.Â
One...
Yes, that will work fine. The opto ground/- connection goes to the black controller brake wire and the yellow would go to the opto + connection.
-- Gary
48V Controller (Model LB37) Yi-Yun Brand Controller
Electrical Parts - 101210
Shipping Weight: 1.0 lbs.
This 48 volt controller has 7 connectors.
Rated Voltage 48 Volts.
Max Current 50 Amps.
Useable Motors: 800 to 1500 Watts.
its on the TNC scooters site...
So maybe i am not understanding the opto out of the current LVC boards that i have. i simply tied the red wire from each of the 3 LVC's out together - same with the black wires and then connected to red and black of the controllers BRAKE input? I cant tell if its actually working - i did loose a...
your saying you only need one but that means individually plugging and unplugging for each group 3 separate times. I could just connect to my hyperion duo?
so its confirmed i need the full monty!
I have a 18S2P Lipo config 6S x6 5800 Turnigy Lipo approx 75v off the charger.
i am trying to understand the difference between
Lvc/hvc board + charge controller + battery medic
and the full v4 BMS?
today i have a 75v lipo charger that charges at 5A but its not a balancer.
i want to plug it...
seems like they are trying to fix some difficult bugs in their close to final design. until they fix them and have a run of the boards that are defect free i dont think they know. their are a lot of us on this board that have projects that need this yesterday.
make sure you dont have any pool chemicals like cholorine or acid or fertilizer. these combine with the humidity and cause corrosion on everything. I too live in South Florida.
so im clear. i connect these BMS boards to the balance taps coming from my LVC boards. I connect one side of the BMS to my power supply and the output of the BMS to the battery pack
Gary, i noticed you are now out of your trick LVC setup? when will you have more. i fried one of my turnigys while waiting for the 4.0 BMS?
3/4/5/6-Channel LVC + 3p/4p Parallel Adapter
Details
New
3, 4, 5 or 6-Channel LiPo Low Voltage Cutoff Protection Circuit + Parallel Adapter Kit...