Recent content by Anamelesssomebody

  1. Anamelesssomebody

    Veeco reverse trike

    That looks way cool. I'll take one in yellow. If that comes to market it would make way more sense then one of those so called smart cars. Probably won't happen here tho. :cry:
  2. Anamelesssomebody

    Nice 9 second electric 34 ford

    I was reading the latest hot rod magazine and it had this car in its project cars section. It is a 34 ford body with 2 400 hp motors and a lot of batteries. It's supposed to run 9's in the quarter or 100 miles a charge with a flip of a switch. It's not quite done yet. I read the mag article but...
  3. Anamelesssomebody

    Ok I would like some more mph..mxus help

    That was some good explaining by cell man. It gives you a lot of options. Since he thinks your battery will work a few different ways, I guess just the wheel kit if you go the Mac route. I'm in galloway.
  4. Anamelesssomebody

    Ok I would like some more mph..mxus help

    :roll: :roll: if you upgrade, what are you going to do with the old stuff? Edited to get the arrows right --------------------------------------------------------------------------------->>>>>>>>>>>>>>>>>>>
  5. Anamelesssomebody

    NJ- When an e-bike is not a moped

    Federal law says their bicycles when for sale across the country. NJ State law says their considered mopeds. NJ DMV says they won't register as moped. Yea that pretty much sums it up. Now we just have to wait for the legislature to enact some ebike laws. I'll keep you posted. :lol:
  6. Anamelesssomebody

    NJ- When an e-bike is not a moped

    LMFAO. :D :D now that's funny, well at least I thought so. Dogman, that was the state motor Vehicle commission writing the DMV laws. they were going to make the dmv statutes the same as the states and realized the state didn't agree with the fed so they went with the fed. So the dmv...
  7. Anamelesssomebody

    NJ- When an e-bike is not a moped

    Dont have much time now or my glasses but he is a direct quote from the minutes of the DMV meeting where they decided to follow the fed law regarding motorized bikes. Guess they think the Feds thing is law too. Maybe someone should tell them it's only a suggestion. After is more of the minutes...
  8. Anamelesssomebody

    New Jersey - When is a bike not a bike?

    Ahhh, posted here in a link instead of where I wanted to in this thread. http://endless-sphere.com/forums/viewtopic.php?f=3&t=37672 Dang I miss my glasses. Sorry :oops: maybe the two should be combined ther're the same thing mostly. This subject gets debated to death over and over when what...
  9. Anamelesssomebody

    Just ordered a mac 8T, torque arms/plates?

    Are these still available ? http://endless-sphere.com/forums/viewtopic.php?f=31&t=29129&hilit=Doctorbass They look quite good.
  10. Anamelesssomebody

    NJ- When an e-bike is not a moped

    Sorry,you didn't say much just quoted some law didn't know what you were looking for. Here is a long thread on another board about the same thing as you. http://visforvoltage.org/blog/jerseygirl/10170 You can use a mobility scooter but not a trike. You can use a converted bike if you are...
  11. Anamelesssomebody

    NJ- When an e-bike is not a moped

    And your point is ???????? The state law is anything with pedals and powered is a moped. Its in direct conflict with federal law. The DMV attempted to make their law correspond with the state law. Then they figured out it was in conflict with federal law. And said so. And changed their laws to...
  12. Anamelesssomebody

    Need hub motor wiring help

    MadRhino If it was just a sensor I probably would have just replaced it but it is a resistor or something that went bad. My soldering skills are nonexistent and im not sure what to get or where to get it to replace so this seemed like the best solution at the time. I am getting a dual mode that...
  13. Anamelesssomebody

    Need hub motor wiring help

    I think I have this problem fixed. I am getting a sensorless controller from Lyen. :D Hope that works.
  14. Anamelesssomebody

    Need hub motor wiring help

    The ones for the other wires measured 46.6 - 46.8. The one for the green wire which didn't measure before measured 75.7. Maybe I didn't have a good connection before when I checked continuity. Thought I did as I tried a few times. When I measured the voltage before I took the motor apart the...
  15. Anamelesssomebody

    Need hub motor wiring help

    Hmm, maybe. Didn't think of that. Thanks for the suggestion. I'll measure it when I get a chance. Maybe it knocks the voltage down for the halls. There is 6 point something volts going in an 5.0 volts coming out when I test them so maybe.
Back
Top