Recent content by andreashb

Hey I currently have a setup with KT-LCD3, 3000w MXUS motor. I have used a twist throttle before, but I want to install a PAS sensor. But when I connect it and twist it, nothing happens. I can't seem to find a setting to turn PAS sensor on. Someone know how to do this?

Nice, thanx! Will make it this summer :)

Sure! But the cops would still see the cables running from the bell :lol:

Can you give an example of a use for this? I think like pushing a button hard would make riding it worse

What do you mean by: "Hide it in you sleeve and connect it to your thumb with a wire." ? Using a half twist throttle and modificate it using a gearshilf aint that stupid! That way it won't look illegal at first atleast. Using a small potentiometer is not that safe unless it is spring loaded...

Are you sure that a resistor in series with the signal line wouldnt cause any signal trouble? I though of putting the resistor on the positive cable.

Hi, I have tried to find answer to this problem for a long time. In my country I am not allowed to use another throttle than a PAS sensor. Using something like a twist throttle would be seen as using a moped (the bike can only provide motor power when you are pedalling.). Here is my plan: I...

Picture

Hi! I am currently working on some throttle modifications, but I have some questions. I know the max throttle voltage is at about 5V. But what is the amperage? Is it continous through the whole throttle process? If I want to limit the max voltage to say about 0.4V. (Which will make my 3000w...

Hi, I have recently installed a 3000w kit (mxus) on my bicycle. (btw it is crazy fast!!). But I cant seem to fit my rear brake calipers. I wont even fit the disk because it is so small space. I have tried to bend the frame, but I will not bend anymore incase it breaks. I wondered if it was...

But the XT150 are not waterproof, and also when i connect the battery the plastic melts a little bit everytime because the small shock. I use XT150 at the moment. Also when i use it I do not trust them so I use electrical tape over them. This takes time because i always remove the battery. So an...

Hi! I have an 3000w motor, with a 72volt battery (max about 80volt) If my calculations is correct it would draw about 40ampere when max. What I want is a new battery plug since the one I have is not good and doesnt handle the power. Also I need it to be waterproof. I have been looking at...

If I can turn the throttle and the LCD reacts + I get reading from the temperature on the motor, that would mean that the controller is working? Also which cables should I try? The hall sensors or the other three cables from the motor? Can I destroy something by putting hall sensors into wrong...

Hi! Recently I have built an ebike. The motor is mxus 3k turbo (3000w) and the LCD is KT-LCD3. I attached a picture of the controller. This is what I have plugged: LCD Motor - three color cables + 6 halls sensors Battery Throttle (also tried with and without brake sensor) I only connected...

Thank you so much!! Can't wait to test out my high powered ebike. Will post a video if it works ;)