Recent content by Andrew707

Yes, it is off. After like 10 tries I was able to install stock firmware. Whenever I get the error I just unplug and plug to other usb port and try again and keept doing that until it wrote program memory and looks like the bike is working fine with stock firmware. Would be nice to get OSF...

I wanted to try out the settings you recommended and for some reason one time flashing worked fine but after that both JavaConfigurator and ST Visual Programmer can't write program data anymore I've tried putting stock firmware and looks like it's able to read everything and write DATA and...

That's fine if the speed doesn't show up for a few minutes. But my main concern right now is that once I start pedaling motor is not engaged until a few seconds later. Once it start working it works fine but after a full stop it takes a few seconds again for it start working again. Never...

I installed OSF on VLCD5 and just went out for a test drive and looks like I have another problem. Speed is not shown and E02 is blinking. When I turned off "Set parameters on startup" option in configurator, E02 is gone but speed is not working. I noticed that at the very beginning motor is not...

Corner brace worked pretty well!

Wow this is really creative! :o Thanks for an advice! I've bought some corner support and washers. Will try to make this work. Will post picture once done! :)

Hello, I'm doing my second TSDZ2 build and once again I have a problem securing the motor to the frame. My bike has internally routed cables which come out at the bottom next to the bottom bracket. There's additional piece of aluminum welded at the bottom of down tube where the opening for...

Thank you! Next time I'll disassemble the motor I'll try to clean connections and see if old motor still works!

Hello, I've had lots of issues with my inner motor after disassembling it and applying thermal paste inside but eventually I made it work...for like 50km. I went for a longer ride and the motor was working fine while suddenly the power dropped and I've got E04 error on VLCD5 and I wasn't even...

Good idea! It was worth a try. However, the problem persists. Stock firmware doesn't show E04 error but the motor stops working after biking for half a minute or so. :( I was thinking what else could be wrong... So back in the days when everything worked fine I noticed that there was a bit of...

Yeah, I saw that too but my motor is 6 pin with no throttle function. No, I didn't do temp sensor mod. The only modification I did was heat dissipation "improvement" after which I started having all these problems.

Can you please share some pics how it looks like? Yes, I can pedal easily with the motor off. There are no issues. And when it works after system start up I don't hear any strange noises and everything seems normal. I'm a bit reluctant to open it up again since I already nicely put everything...

...my story continued... So I was extremely happy that after two months I can finally ride my bike again so I went to test it out on a longer ride. I biked ~50km no problem until suddenly the power dropped and the screen started showing E04 error code on my VLCD5 display. After testing things...

Hello, Just want to share an update on this. Few weeks ago I've got that weird sound problem described above. Tried many things and nothing worked. Recently finally received brass gear and put it in without any grease at all (just to test it out for like 100 meters) and the motor made the same...

Hello, I just swapped my controller to the new one, installed 48V firmware and flashed OSF. Went for a test ride and everything worked fine for 50km and then motor turned off and is showing E04 error on the screen. What does this error mean? Sometimes it starts working for like half a minute and...