Recent content by aniken

BIKE FIXED For those who may have similar issues... I was suffering cutting out and low voltage warning issues. I thought I had ruled out bad power connections as I had run the bike on the stand with the throttle wired open so I could manipulate all the problem areas with both hands to make it...

To the guy who has the noisy drive keep building it up and don't worry just yet. Mine has really taken some punishment and been taken fully apart and reassembled twice now and done thousands of km. The first time it did chew a bearing up that cost less than a tenner to replace, the second time...

Hello all, its playing 'silly beggars' again For a while I have had coggy / notchy sensation through the pedals its kind of like the motor is pulsing rapidly instead of running smoothly. This was most apparent in PAS mode and seemed to clear using throttle and at higher motor speeds. Today...

:D DRIVE WITH MASHED UP BEARING FIXED AND DONE 120 MILES WITH NO ISSUES! :D I wanted to wait until the rebuilt drive had got a few miles under its belt before reporting a final closure post. I got the drive rebuilt with a new bearing. I had a few issues... I had to sand with very...

How I removed the outer bearing shell from what was effectively a blind hole. I am sure there is an easier way... but I couldn't think of one so I did this! ZJsySWVZSKY Details of the bearing and more for the benefit of other users. gfoI29lsSbQ

Thanks for being the only one to address this annoying issue. To be honest as I am sure you can see I have 'bigger fish to fry' at the minute as the unit is reduced to its component parts! I did try to explain this annoyance about a year ago without anyone else having the problem. From what...

OOps sorry still learning, Should work now.

Yah I cant believe a metal gear has worn so much when it runs on a nylon one. If you look at he video above the pictures I show the condition of the nylon cog. Its not too bad, doesn't look chewed up like this one? What I dont show is them meshed together. I tried this and they fit together...

LET THIS BE A LESSON TO YOU ALL, DONT IGNORE NOISES! You have to see this video! Little help?? Dw2wNuyzOgI

Okay so here is the final (I hope) tear down video. I would like to know if what I have found is normal or not please. Also hopefully you should see below the photo's of the helical part I think has some unusual wear on it. I think it shows it quite well. If you look at the mid shot although...

I would never have thought of jacking screws! Didn't even notice any extra holes! I had a night off to go watch the first nocturne cycle race meeting in my town. I just spent all evening wondering, "could I win if I was on my EB!". It was really cool lots of sprint finishes, crashes and a...

Thanks for your detailed answer Kepler. I took apart the motor as you suggested and saw what was inside. That's about all so far. I did just go back and read the start of the thread. It didn't make sense before as I had to break open the motor and see the parts my self to see what was meant...

Not good news. Looks like I may have to make good on my earlier "I'd buy another tomorrow" comment. Back to the hub motor for a while and if that breaks god forbid pedal power or the car! :shock: Observe... http://youtu.be/WoU9L6M2JwM

Okay so hopefully the following videos explain the issue. I assembled the bike over a year ago and I obviously forgot how it went together so my previous posts didnt make much sense. Only the chainguard can be removed with a screwdriver obviously! Sorry if they are too long, its the first...

Sorry to be the dumbazz of this thread but if anyone can tell me about the power off feature of the controller I may be able to figure out why my bike turns itself off when you stop moving? If you keep moving i.e. the display is showing kph readout its fine, if you stop it turns off. You have...