Recent content by Beli

This has nothing to do with the ESP32 and quite sure the VLCD5 is faulty (memory chips always have limited number of writing times and yours obviously has gone earlier). For other displays please see experiences reported in earlier posts.

That does not really help. According to the FT232 datasheet only 50mA can be drawn - which is not enough for a save ESP32 supply.

Using a FT232RL? The problem is that it doesn't provide enough current (so the voltage is dropping down).

No. There are many differences (in my opinion making it better). No. And I don't see any advantage of that.

No, you need the display. First of all for turning the system on. You could use a switch for that. But you had to change the software too. (I made it completely different, use ESP32 boards with display.)

Yes, you can leave it connected to the throttle input (can be selected within the android app).

It's the motor power and you will not get a reasonable human power reading, there were only some approaches in other open source versions (standard non ESP32) but for this purpose the sensor in the TSDZ2 is not really good for.

Just search in this thread for SW102 and you will find a couple of answers: https://endless-sphere.com/sphere/search/145960/?q=SW102&t=post&c[thread]=103318&o=relevance

No - as I already mentioned earlier. The firmware of this project is especially prepared for the update. This is not included (and intended) by the emmebrusa firmware. And all software (including ESP32 and smartphone) have to be reasonable up to date for fitting together for doing the update.

What firmware is on your TSDZ2? Did you already flash the ESP version? And did you enable the bootloader? You can only update the firmware with your phone. You have to take this steps first: TSDZ Controller Flash

This adapter quite likely does not supply enough power/current - at least that's my experience.

It crashes on my Samsung S10+ when trying to make the BT connection. Version 2.1.12 works for me with Android 12.

I integrated the latest changes in my version and gave it a trial today (with activated torque smoothing). I didn't notice significant differences - at least it is running smooth with no problems so far (so as intended).

:bigthumb: Thank you for anticipating that I would ask about that :lol:

@mspider65 I was just about to implement some changes in my adapted ESP32 LCD version concerning torque (my earlier recorded Torque/'Newton table to get reasonable human power values and connected to that I was wondering if it would make sense to linearize the torque values like it was done for...