Recent content by bomberider

Linux operating system wouldn't support MQCON PC website, is that what you are saying?

Would anyone know if Linux operating system supports the MQCON PC website

Do you know if Linux operating system supports MQCON PC website

"Following dominik h's advice, I measured the throttle voltage for both minimum and maximum values. Once I had those readings, I entered the specs into the Cycle Analyst. I didn’t make any changes to the controller, which makes sense because the issues I was facing stem from the Cycle Analyst...

A Big Thank-You to Everyone Who Helped! I just wanted to express my sincere gratitude to Dominik H and everyone else who lent a helping hand while I was troubleshooting my bike. Thanks to your insights and patience, I was able to get things back up and running—everything is running as...

Did you have a chance to view the pictures that I had posted? Thank you for the suggestion, I could use your worldly opinion? it would mean a great deal to me,🥱being the expert that you are😱, and I really could use your extensive knowledge.😱 I have kind of hit a little road block.😫The throttle...

I did get the hall test done, the Throttle min voltage value 1.11 Throttle max voltage value 4.45. Throttle twist unfortunately the value didn't move off 0.00 to 0.01. I had noticed that it wasn't moving off 0.00 so I didn't fully twist throttle to max. I do have another throttle that I can...

"Did you do the hall sensor test in the app? That is the only thing that is really necessary. Does your app show throttle values (0.9–4.5V) when you turn the throttle? The 0.01V shown on your screenshot is way too low for a hall throttle. If it does not show throttle values, you have no throttle...

Hey everyone, first off, thanks again for your patience and advice. I wanted to share a bit about where I'm coming from—I can take this bike apart and put it back together again without breaking a sweat, but when it comes to the technical setup and troubleshooting, I’ll admit I’m a bit out of my...

All the settings that you see other than a live feed (if there is one) are factory settings when I pressed the reset it changed the settings to factory settings when i pressed the reset I assumed the controller would reset back to the original settings of the motor and other functions like what...

I will be posting screenshots of Sabvoton controller MQCON app images asap

_"If you're talking about the motor, I've had it for five years, and it's never burned up or had overheating issues. However, if you're referring to the Cycle Analyst, it burned out shortly after I bought it. One more detail you might not know—the Cycle Analyst I was using at the time (and no...

just to make sure can a1200w motor go over 100kph. because if it can't the motor i have does, when I first rode it , it went to 120kph

just to clarify can a 1200w motor go over 100kph?