Recent content by Brandon122603

if you use a differrent axle that is slightly bigger it is posible to swap out cone and bearings for cartridge. I found that out after accidentaly damaging a cone. i ended up remoiving both cones and bearings leaving a hollow hub. after checking fitment of sealed bearings i used those. i...

Not sure if it was plumbing solder, it was with my grandpa's plumbing stuff but said it was 64/44

Also, is there a bms you would recommend?

Not sure if they really are Samsung cells. According to a discription from the contacted manufacturer it is missing information in the wrap and on the cell itself. -SAMSUNG SDI Confidential Proprietary – Spec. No. INR18650-30Q Version No. 0.0 Wanmook, Lim - 15/16 - Additional remarks ■...

I used a propane soldering iron and flux and tried to be quick. There were about 5 cells where I sat with the solder and iron for about 10 seconds to get it to stick. I was hoping to close this off within the bike and charge it through a port so it doesn't have to be touched. I'm going to...

It's a 1 1/2” piece approx. Folded in 1/2 twice. Should I add another or use something different all together? What is a 60/40 solder job? Drawing of parallel connections added. Can I leave the battery assembled with it connected to the charger and controller and use/charge is as is?

I'm not happy with the solder as well, but after trying 3 separate spot welders and all three not working I decided to try and solder as quickly as possible to avoid transferring too much heat. I received the cells in new condition, the spot weld marks were from my attempts with the 3 failed...

I see I likely posted in the wrong place since I'm using LI ion and not lipo, anyhow im building a battery for my 6kw cyclone motor with the 80 amp controller. the cells im using are samsung i hope are authentic samsing 30 Q's(unsure as i bought from an unverified vendor) my configuration is 14s...

I'm connecting the 80amp bluetooth controller for the 6kw motor and have no idea where to connect these few things: the high brake, which comes off the throttle with one wire the low brake which has 3 wires the phase line meter the soft\quick start(does it connect to itself?) the speed...

I suppose you both are right. Better to be safe than sorry. I'll just let the customer know they need to upgrade the battery beyond budget if they want more out of their bike. Thank you for your input.

Say the 30q cells have a higher discharge rate than my mystery cells and , would this only cause the bms to stop all battery packs from being used, leaving the mystery cells with partial charge? Then I'm assuming i would need to charge separately due to the voltage differnce. My initial battery...

2-6KW Triple chainwheel kit, 80/60A 48-72V BT programable controller/ LCD , top speed 125km/h waterproof connector, Silence, 500Nm torque, no over heat Square tape/ISIS BB I bought this kit from cyclone but cant seem to get a response to my emails. I bought 60 of what I hope are genuine samsung...

I'm new and still learning all the specifics, but would this work? I know they're cheap knock off crap at best. But would two of them make a useable 72v 20ah battery. I'm not worried about them lasting long, I'll lget the warranty coverage plan so when they fail i can get them replaced or my...

I usually build gas bikes, this is my first ebike build, boy did i have allot to learn. Any and all help would be greatly apreciated. I would first off like to ask Skaiwerd a question as it turns out I'm using the same fatbike for my build, well kind of. My first question is how is the frame...