Recent content by bruwie

For me personally, this option would be quite sufficient. As simple as possible.

Hello, buba, I always drive with lights on, which I switch on with the up button. Could you make it configurable that the lights are switched on when the display is switched on? Of course it's not so important, but maybe others would use it as well. Sometimes I forget to turn the light on again...

I have a little problem. In the Odometer Field (Main Screen Setup 7/1) the motor temperature is not displayed. In the Temperature field (Main Screen Setup 10/1) the temperature is displayed. However, I would like to use this field for the 10/2 Battery state of charge in percent. Do others have...

Hello, I solved it this way. The five-pole Bafang plug now goes to the JTAG. Unfortunately I already sealed the display with silicone, otherwise I would have taken more pictures from the inside. Unfortunately I forget this again and again. I drilled a hole for the motor cable. The adapter...

Target Chip erase Load bin file Target program After flash

Look here https://github.com/OpenSource-EBike-firmware/TSDZ2_wiki/wiki/0.20.0

It works for me with STM32 ST-LINK Utility. Thank you very much for the hint. The ST Visual Programmer does not accept the firmware.

Hello, Thank you so much for all the work. I wanted to flash the display. I deactivated the protection but I got an error when importing the firmware. Under Ubuntu 18.04.2 LTS it works for me

Hello, unfortunately the git does not compile since 25.04. sdcc 3.8.0 win7 64bit. This script will release a new version of the firmware, e.g. 1.0.0 Please enter the new version number: 26.04 Cleaning files... Done. sdcc -c -I../common/STM8S_StdPeriph_Lib/inc -I. -I../ -mstm8 -Ddouble=float --st...

Hello, I am using the latest version 0.14.2. What is the best way to turn on the light using the lcd3 button? I use the BuM LED front light for e-bikes with an input voltage of 6 to 42 volts. At the moment the LED is connected directly to the battery.

That could be the problem. My cable was also too long, but for flashing the LCD3.

The tabs are in the st visual programmer on windows

Hello, my name is Hergen and I come from Germany. I have the 36 volt motor with a 36 volt battery pack. I flashed the LCD3 with 0.2.hex. Then I flashed the controller with 0.2.hex. The display starts and I can zap and configure through the menus. I set the battery pack to 10 cells, 16 Amp, 30...