I have the same problem with my ME1302... low speed is OK, but over around 1000 or 2000 U/min the motor start to oscillate. I changed many parameters, but no sucess..
Thanks Darsey for you hints,
I used a DCF for the ME1114, so I think the main parameters must be correct.
Until now I use standard encoder settings ond dont trace the motor. Its the first time I use a PMAC motor and I thought, there is a easy solution.
So it seems I have to dig deeper...
Hello,
I have a probelm I can not solve...
after some days work I got my ME1114 with the GEN4 running. Problem:
After some seconds spinning, the motor slow down and stop. Only with power recycling I can get him spin again.
(I use the motor in speed mode..)
The Battery voltage is stable....
The...
Hi,
someone have the "CANopen utilities add-in" for Excel??
I try to generate a Object Database from the Master Object Dictionary.xls, but I got a error message, the add-in is not installed... :roll:
Hello,
I try to get the ME1114 running with the GEN4, but I dont have the Firmware for PMAC motors.... can someone send me the fitting Firmware for the 80V/350A controller? :oops:
greetings, Michael
Hello Darsey,
if I understand you correctly, you have shielded the B-lines? How so?
If you do not put B- on the chassis, I would guess you have more noise on the frame!?
What safety advantage do you have by not connecting the frame to B-? (I guess you don't have a very high traction battery...
Hello Darsey,
very interesting, one question:
You don't ground b- at the controller, but it is grounded at the battery pack, right?
You use a cap between b- and b+, which size you use?
Greetings, Michael
Hello,
I can not solve a problem since many days:
My GEN4 lost the CAN connection to the PC (if I like to program) and also disturb other CAN devices when the controller is in operational mode.
In preoperational mode everything is fine.......
I checked the CAN singal with a scope and the signal...
Hi all,
I have this problem now: For the Battery I use a EMUS BMS; for the Motor the GEN4 bcs. I change to a Twizy Motor.
Before I had speed pulses from the old motor to feed the BMS for distance calculation.
Now not anymore.... Is there a way, to generate speed pulses in the GEN4 to feed the...