Recent content by buzzfirst

Did you charge your battery, may be low voltage cutoff in controller? Sometimes it's the simple stuff.

90km/h on those fronts on a tadpole. Evil kneivel would love to have those guts. My tadpole gets ridden the most and I love it but just not sure that one would be rideable at that speed.

Hey Ypedal, if you have another place to put the stuff, you can most times put the drive in the freezer for about an hour and then it will start up and run for at least a couple of hours. It only works once or twice but I have saved ata like that before. Get your stuff off as soon as possible...

I would suggest keeping power driven mechanicals to the very very minimum. Parents today will not hesitate to litigate against any person or place that harms little Johnny. Even when little Johnny is a known pinhead with absolutely no home training. A crank drive setup would almost certainly...

Check the bottom of any of Justin's posts, there is a link

I would go the 48 volt route. With the larger motor you may, again may, have a little unused power for the speeds you want to accomplish. The 600 watt motor doesn't seem to be enough to go 30 mph for any length of time and if it did it would be dependent on rider profile and weight. I seem to...

I like this frame a lot. It looks like it could be built by far more people than a tube frame. Cad layout of the frame sides and a few :) more details looks doable. Keep at it for all us non tube welding guys.

The speed of the hull will be the determiner.Each hull has characteristics that will determine planing speed. This speed will vary with weight. The manufacturer should be able to tell you whether the hull will plane with the speed/weight you plan to have I think you are on the right path...

Hope you are not in the U.S.A. The last time I checked they would not sell anything associated with the Cri Cri to the U.S.

Clean cover and freewheel thoroughly then J-B Weld. If you just use your pedals for backup it should last a lifetime.

Hi Matt, I agree with a lot of what Kurt says. A few additional ideas would be: A unit that would not modify the existing drivetrain so that one would not have to break his existing bike to install this one. For a broader appeal it would seem that a lower kv motor and a controller that...

Thanks for the quick reply, now to find that bench supply.

I have several different configurations of konion, lifepo4 and nicad batteries. I have never owned a bench power supply and was wondering what would happen if I used it for a charger say for 10 lifepo4 cells. Say I set the voltage to 36.5 and the amps to one amp for instance(once the pack was...

Are you in the US if so how much was the shipping? Did a manual come with the charger? One last thing What is the purpose of the other two trimmers? Thanks, I need a new charger for some lifepo4 I just got.

Score thread listing.