Hello im looking for the thinnest insulation for hub motor phase wires. I have 10 GA silicon insulated wire but they drag along the shaft and i cant seem to fit 3x. Whats the type of wire/insulation they normally use in BLDC. Couldnt find it anywhere. Thanks in advance
I own a few batteries 20s 12p, 20s 15p, 20s6p. 17s 1p, 22s 6p , thats not a problem. Wont be using it as its useless im just exploring my possibilities here. As to say its is dangerous to have it in my possesion is a bit over the top. It wont burst in flame spontaneously by sitting on my shelf...
So basically i should just isolate the bad group of cells. What is a good way to monitor voltage under load .. i cant see the sag on my voltmeter but i guess if i monitored the voltage of that said cell under load i could
Recently individually charged my 20s12p pack with a ISDT q6 to SoC 100%
c1 4.19
2=4.19
3=4.20
4=4.21
5=4.19
6=4.20
7=4.19
8=4.20
9=4.22
10=4.19
11=4.20
12=4.19
13=4.18
14=4.21
15=4.22
16=4.23
17=4.23
18=4.25
19=4.22
20=4.19
The bms trips everytime i put high load over 35AMPS
PS.
Cell*6 was...
thanks i kinda figurred it out myself monitoring the bms it cut starta bleeding at 4.20 volt and at 4.25 volt it trips the bms overvltage protection.. Im charging every cells with my isdt q6 trough the balance leads.. 40 ah 20 s.... lol pretty long
if my cells are unbalanced and i just plug my bulk charger when certain group of cells reach 4.20 volt will it damage them to let the charger charge the other group of unbalanced cells ? or should i let it charge until all groups are at 4.2 volt ..?
Came across a problem recently and cant seem to fix it. ordered 2 of these chinese controller and both have 5volt signal and 5volt input on the throttle plug. Motor runs fin in self learning but any attempt to connect a trottle is not working any help? Is there some kind of controller that works...