Recent content by crimsonsnake0

its a 48v 2000watt chatpart

hi i have until recently had no trouble but recently my bike is cutting out then when it goes again the motor is in reverse. then after a few minutes it corrects itself and i can continue my journey no problem. could this be throttle motor or wiring or controller prob. damp or water ?regards

so i could possibly get 25 miles if i go easy with throttle ? thanks for that

hi i have just travelled 19 miles with my ebike. 12ah headway batts. is that good average or what ? still had 55.4 volts left unloaded. my set up is actually 17 headway batts rather than 16 so starting volts is 60. dont use bms at all and never had 1 over charge. how far have you all travelled...

sounds silly but take the wheel of and turn it around then it goes forwards job done !!!!!!!!!

try ebay regards

nothing but praise for mr ping here from the uk. ordered a charger from him on a sunday night it arrived on wedsday morning 3 days to get from china to uk mr ping is a star seller.

hi i would like to get all of your ideas for positioning of controller please. at the moment i have mine on the side of my pannier rack but im a little unhappy with this because of the wiring mess and would like to make the controller more stealthy. my batterys are in a topeak bag but the...

hi i know 3.2v is the nominal for headway batt and 3.65v is supposed to be max but is it ? or will they take more before damage regards

hi does anyone know if pings KP6002WL MODEL charger voltage is adjustable ? any help please would like to up the volts a little thanks.

hi i have a 60v controller that had a throttle problem. the bike was still going when throttle was off although the bike still perfomed fine. i have since replaced the controller and my throttle on new controller is fine so the problem was with the old controller. i would like to test the old...

hi everyone just a big plug for mr ping . i bought a 48v charger from him on saturday night he emailed on sunday to confirm order and to say dispatch would be monday. he shipperd it as stated and i received it at 2pm on WEDSDAY AFTERNOON !!"!!! 48HRS FROM CHINA TO UK .THIS MUST BE A RECORD...

okay just had a look at the diagram from grindz145 will go that way but the volts only go upto 44 my system will be aroung 60v any ideas on resistor for that or will just a 100 ohm resistor be okay ? regards

hi so if i take one 12v 20amp switch and solder a resistor across the 2 terminals and then connect my plus from controller to it then connect the battery to the other switch terminal that will work and wont blow up ? regards

hi thanks for that but wont that blow the switch up putting 50v plus through it ? forgive my ignorance please thanks