Recent content by deejayuk

It still doesn't work so unfortunately I'm back... Voltages measured from hall sensor connector now change from 0.02v to 5.02v in all 3 sensors which is correct afaik. Have sent another email to conhismotor and will update soon...

Thank you for advice, yes still appears to be a faulty sensor and have ordered some SS41 latched bipolars from a UK supplier, hope these are correct type for a conhismotor. Moral of story, do not entirely trust the tester as led's switch off below a certain voltage. If it doesn't work I'll be...

Carried out one last test and might have found the problem if not the cure, used multimeter to test actual voltage from hall sensors in connector. 2 measured 0v-5v off/on but one measured 2.9v-5v off/on ??

Have tried all 36 connections but unfortunately no luck. 3 connections did make the motor spin briefly and by opening and closing the throttle it would keep spinning but the motor sounded coggy. The tester is showing the motor should work. The tester is also showing the controller should work...

Have not tampered with new replacement controller but have had a look inside, no sign of bad soldering and the wiring/ circuit board looks identical to original, a mystery, thank you.

Thank you for your suggestions, what happened was 2 phase wires from the original controller touched at the connectors and fried the FET's, part of the main board looks burnt and still have it. The wires from connectors to hub look fine, have checked with multimeter and found no shorts between...

Hi guys I have a Conhismotor ebike 48v 1000w (http://bit.ly/1UIkvjD) and bought a replacement controller (http://bit.ly/1UIoUTw) from same company when the carrier collapsed with 2 motor wires shorting. Unfortunately the wheel now only judders or spins very briefly so fearing motor damage bought...