Recent content by Deutch420

6000$ usd!!?? Congrats!!! I can't get 2/3 that price and I have better parts across the board. Congrats man.

Ive been eyeing up this one http://www.ebay.com/itm/271488313008?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT 24v, and only 136$ shipped. somethign like 500 of them sold, and if you check the history, no one is pissed. you can also look on youtube for the same motor, and everyone...

i got a quote from him a little over a year ago for the same thing. Its an "unadvertised" price, so i will PM you the deal he offered me, to give you a round about idea what he is asking for the swingarm. It did involve me sending back my old one along with $$. PM sent

You can say that again!!! The motor only pulls 30 amps max speed. 15amps middle speed. And I went a few miles with it. Still yet to have a discharge under 12.5v Lol. But I did go with the massive 60lb 125ah battery. Once I go into the bay I know I'll be consuming more, but these fresh water...

i think i have it figured out now. I charge at 10amps. charger drops from 10 amps to 1 amp once it hits 14v. after surface charge is removed, im left with a 12.75v charge. works great. last discharge was to 12.51. icharger at 10amps got it to 14v in 1 hour 29 minutes.

Im loacted in Central NJ agreed. the 4S packs are 25$ each. there are no 3S packs cheaper than that. So your basically getting 9x 3S packs, for 75$ which is about 1/3rd new price. plus your getting 9 more cells free from the 6s batteries. so thats 36 cells. which could technically make 9x 4s...

theyre 4S packs, not 6S. but if your asking if a GOOD 6S pack has the same bad cell readout via the balance tabs OR voltmeter, no it doesnt. Also, if your asking me if the cell readouts match, the answer is yes. I have an iCharger306, voltmeter and aCellLog 8M. they all corrilate and give the...

better than 120ah for 95$?

according to the replies ive recieved above, surface charge is the artificial volts shown at the battery terminals after charging. The volts will dissipate down after charge, eventually hitting the real, "rested" volts. You see higher volts at the terminals after charge b/c "In order to recharge...

..

I have over 40 other lipo batteries between my other bikes. All cells are fine after hundreds of cycles. And has worked fine for 2+ years. Shit, I still have 6s batteries holding 4.1v charges and they're over 4 years old with 400+- cycles. They work fine. I have the same 4s hardcase packs in my...

While I understand and comprehend what you said, I'm still confused. For example, I left my icharger on the 2.4v per cell option like the charger manufacture, battery manufacture and you suggested. However, I got concerned when it got near 13v (charger readout), so I stopped the charge early...

Not to hijack my own thread, but is anyone familiar with charging a basic deep cycle marine Acid battery? I have a few questions regarding the charging. I called the battery manufacture and they say max charge is 12.7-12.9v and max amps during charge is 10amps. But then they say to charge at...

Balance leads always. With a balance charge at the end, never rushed or removed from the charge prematurely. I charger 306 with a meanwell 1000. I too am suspicious of it always being the outside cell. But all the packs are the same, where I realised the balance charge was taking much too long...

Thanks for all the replies guys! Seems like some of you have been answering others for me! perfect! :D The batteries dont have that many cycles on them, so i know the cells have some good life in them still. To those asking how i know they're bad. On a charge to 4.15, 3 cells hold 4.14-4.15...