Recent content by drpop

Bingo! That did it! The sensor is soldered in and is also working, just waiting for a tool to remove a sheared bolt and I can silicone it all back up. I've seen some chat about tie wrapping the sensor to the motor... so I'm going to do some digging for that. Hopefully, be back out on the bike...

I went ahead with the heat sensor mod.. everything seemed to go well... right until I was replacing the right-hand plate where-upon the final hex bolt sheered in the housing. :x I went ahead and had a quick test... and I got an Eo-6 error message - which I am assuming is the over-temperature...

amazingly helpful. cheers.

I've had at from 2mm away all the way up to around 25mm and still no luck...i'll keep trying. knowing that the 'error codes' are actually usefull features is great though! --- My heat sensor arrived this morning and i hope to install this evening. I have the 8 pin 'with throttle' and i...

>For data reading options on display I refer to the display operation manual (it looks to me that 0:00 is the temperature and 6.9 some other data) Phew. You're a star! I'd convinced my self i'd fried something. This makes sense just need to work out how to show current kph now! Is there a...

Hi folks. I'm used to riding a front wheel hub conversion as a tarmac-only commuter and have dropped enough weight (35 kg) in the last few months that I've recently added a TSDZ2 to a hardtail mountain bike so-as-to give me a 'bit of help' in enjoying some offroad gravel trails... not 'real...