Recent content by EndlessScream

I have bought a new TSDZ2, but infortunately it is not working. I would like to test it without LCD display. I have 8 pin cable, so I need to short blue and red wire, but I don't know which pins are these on my connector. Pin 1 is battery +. How to find a second one?

I have made similar cable, because I did not want to cut the original cable and could not find a suitable connector. It is not a problem though. The actual problem is I do not know which pin is for which line (SWIM/RESET/5V/GND). I see you have connected 3 wires (SWIM, RESET and GND). How to...

I would like to flash my controller, but suprisingly my speed connector has only 4 pins (not 6), so I don't know how to connect ST Link (and I don't know if it is even possible this way). I have measured voltage levels and I have identified 3 pins (ground, 6V for headlight and speed sensor input...

Ok... I have just tried again several times (with stopwatch in hand). I was holding these two buttons for 10, 15 and 30 seconds, but the result is always the same.

Thanks, I did not know there is a second hidden menu, but unfortunately it does not seem to work for me. I have tried several times this procedure: 1. Power on. 2. On ODO press "power" and "info" buttons simultanously and hold for 10 seconds. 3. Cycle through options by pressing info button...

Are you referring to the hidden menu in the stock VLCD5? It does not seem to show torque sensor readings (only the basic configuration options: wheel diameter, number of magnets, metrics, walk assist, speed limit, amps and region). I have found two posts where someone was suggesting to check...

Is it possible to configure this firmware, so it uses only PAS and no torque sensor? I am asking because my torque sensor stopped working and I do not have a throttle. The motor engages, but it gives me only a little boost on each assist level and it does not increase when I put more pressure on...