Recent content by episani

Thank you for suggesting this display, it looks beautiful and it seems to be compatible with a range of protocols and controllers.

Thank you for your kind replies. I'll post back when I get my new parts :)

Hi, you were both right! I disconnected the breaks, connected the programmer cable (which leaves the motor connected) and also connected the throttle. The motor works with the throttle all the time. So I'm guessing the display is faulty as amberwolf suggested and maybe one of the breaks magnet...

Thank you, maybe that's the reason. Sometimes we look at the most complicated reasons without checking the most obvious ones. Because it said error in the log, I never thought it could be breaks. But you're right, In that protocol the 0x0100 status is Braking!

Thank you for your reply. I don't think the display is the problem as it receives the speed data and in the 10 seconds the motor works I can set the assist levels too. Also, when I connect the programming device, using the display connector, the motor has full power without control, again for...

Hi, I'm sorry if this has been asked before. The problem started a few months ago after hitting a bump, the motor would switch off. To fix the problem I had to switch the battery off, then back on and the bike kept going. Now I has stopped working completely. When I switch the bike on it goes...

That is quite a neat website. I'll have a look. Thank you

My motor is only 1000W, I'm looking for a 48V, 30A controller. I'll have a look to those shops. Thank you for your suggestions

Hi, I'm trying to replace the controller of a Voilamart hub motor with hall sensors with something more sophisticated. I have thought about a Sine wave KT controller with a LCD5 display. The current controller can handle 26A max. Can someone recommend me a reliable seller with quality KT...