Recent content by fany

By the way,a company in Austria developed a LCD display for our KBL and KLS controller.It is based on CAN communication. It is very beautiful.But we don't sell this device.Customers can contact them directly. Link for the test video: MechatroMotive_RCD_EVO2_Kelly_KLS_Demo.mp4 Two links for...

1,Bluetooth function is available on KLS/KAC/KPM controller.Customers just need to buy bluetooth converter from Kelly website. KAC is used for AC induction motor controller with encoder. KPM is designed for brushed PM motor. 2,Three speed function is available on KLS controller also.Right now...

Only the motor is overheated at 30 seconds?How about the controller case temp? 1,We can try to swap phase wires or hall sensor wires to do the Identification angle operation again. 2,We think the motor may not be balanced well.The hall phase timing may not match with each other. The tolerance...

Sorry,it is type mistake. My fault. I meant 2-3 minutes

Here is the correct operation steps for identification angle function. It is for 8080I/IPS controller. 1,Please connect 12V-24V to pin7 and pin6.Pin7 is positive and pin6 is GND. pin7 and pin6 is the isolated power supply for KLS-8080I/IPS controller. 2,Please connect the motor phase cables to...

Here is the correct operation steps for identification angle function. It is for 8080I/IPS controller. 1,Please connect 12V-24V to pin7 and pin6.Pin7 is positive and pin6 is GND. pin7 and pin6 is the isolated power supply for KLS-8080I/IPS controller. 2,Please connect the motor phase cables to...

Here is the correct operation steps for identification angle function. It is for 8080I/IPS controller. 1,Please connect 12V-24V to pin7 and pin6.Pin7 is positive and pin6 is GND. pin7 and pin6 is the isolated power supply for KLS-8080I/IPS controller. 2,Please connect the motor phase cables to...

As you know,KEB/KBL/KHB is based on trapezoidal waveform.So the noise at the starting up should be expected. And the noise will be existed in the whole running. KLS controller is sinusoidal waveform control.There is no noise for the whole operation. Both KLS and KEB/KBL/KHB can do releasing...

CA+External shunt can read battery current.

KLS7240S or KLS6040S is not good at heat dissipation because the peak current is very high but the case is small. We published KLSXX40D controller to replace KLSXX40S controller.The KLS-D has a thicker aluminum plate for heat dissipation. It has a better performance than KLS-S.

Yes,sure.KLS-I used the same features.And KLS-I can provide broadcast CAN Bus function by default.

When I said next month,I meant it is December.You can buy it in December.2015.We will release 0106 version tomorrow. Yes,it is a big holiday in December. The one KLS48121S or KLS7212S is smaller than one from Izeman who has KLS6018S controller. Thanks, Fany

Sorry,only 0106 version can support variable regen,motor temp,12V brake and frequency options for KLS controller. Sorry,KLS used a different MCU and interrupt mode for the detections.Our software engineer said it can not support reflashing job. The KEB or KBL used inquire mode for detections and...

Sorry,we can not add field weakening feature for KLS controller.

01050001:The 12V brake switch and motor temp sensor functions used the same port on pin1. 01050002:The 12V brake switch used the different port from motor temp sensor.pin25 is 12V brake switch while pin1 is motor temp sensor. 01060001:The 12V brake switch is pin25 while motor temp sensor is...